TRAK DPMRX2 Manuals

TRAK Machine Tools Site Preparation Guide TRAK DPMRX2 F16467-44 Rev 062518 Page 1 of 4 Before an Authorized Field Service Technician can perform the machine’s final checkout, the following requirements must be met:  The machine must be in position and placed on its rest pads  To offload the machine, a 6000 lb. forklift with 6’ extension is required.  The machine must be leveled (refer to installation and service manual).  The machine must be wired (refer to the installation and service manual).  The machine must have air hooked up if power drawbar is installed (see the installation and service manual).  The machine must be cleaned. Remove all grease from the way surfaces. Space & Weight • Floor area = 102”x93.875” • Height = 91.75” • Footprint = 23.125”x40.5” • Net (approx.) Weight = 3300 lbs. • Shipping (approx.) Weight = 3600 lbs. • Pallet Size = 76” x 76”, 8” thick • Allow clearance at the rear of the mill to open and work on the electrical box. • A solid and level foundation to maintain approximately 3300 lbs plus the weight of the workpiece (maximum total 4620 lbs) is required. Six leveling screws are provided. Electrical • Machine is only available in the 208 VAC configuration (200 to 240V is acceptable). A separate 208V, 27 amps, 60 Hz, 3 phase circuit is required. For shops with 440 VAC, a step-down transformer to 208 VAC must be used. The transformer must be sized to carry a load of 27 amps minimum. • Machine tool must be earth grounded. Air (for optional Power Drawbar) • ¼” NPT connection • Air pressure not to exceed 100 psi • 17.5 SCFM or 2.5 CFM at 90 psi DPMRX2 Machine Footprints A Overall Width (with Mechanical Handwheel) 99.9375” A1 Overall Width (with Electronic Handwheel) 102.5625” B Overall Length (with Mechanical Handwheel) 89.5” B1 Overall Length (with Electronic Handwheel) 93.875” C Bed width 23.125” D Bed width between leveling screws 20.5” E Distance between leveling screws 32.5” F Bed length 40.5”