TRAK DPMRX3 Manuals

TRAK Machine Tools Site Preparation Guide TRAK DPMRX3 F16467-45 Rev 020921 Page 1 of 4 Before an Authorized Field Service Technician can perform the machine’s final checkout, the following requirements must be met: • The machine must be in position and placed on its rest pads • To offload the machine, a 6000 lb. forklift with 6’ extension is required. • The machine must be leveled (refer to installation and service manual). • The machine must be wired (refer to the installation and service manual). • The machine must have air hooked up if power drawbar is installed (see the installation and service manual). • The machine must be cleaned. Remove all grease from the way surfaces. Space & Weight • Floor area = 102.3” x 96.6” • Height = 96.75” • Footprint = 24” x 43.3125” • Net (approx.) Weight = 4100 lbs. • Shipping (approx.) Weight = 4400 lbs. • Pallet Size = 76” x 76”, 8” thick • Allow clearance at the rear of the mill to open and work on the electrical box. • A solid and level foundation to maintain approximately 4100 lbs plus the weight of the workpiece (maximum total 5500 lbs) is required. Six leveling screws are provided. Electrical • Machine is only available in the 208 VAC configuration (200 to 240V is acceptable). A separate 208V, 35 amps, 60 Hz, 3 phase circuit is required. For shops with 440 VAC, a step-down transformer to 208 VAC must be used. The transformer must be sized to carry a load of 35 amps minimum. • Machine tool must be earth grounded. Air (for optional Power Drawbar) • ¼” NPT connection • Air pressure not to exceed 100 psi • 17.5 SCFM or 2.5 CFM at 90 psi DPMRX3 Machine Footprints A Overall Width (With Mechanical Handwheel) 99.625” A1 Overall Width (With Electronic Handwheel) 102.25” B Overall Length (With Mechanical Handwheel) 92.25” B1 Overall Length (With Electronic Handwheel) 96.625” C Bed Width 24” D Bed Width between leveling screws 21.7” E Distance between leveling screws 18.75” E1 Distance between leveling screws 17.5” F Bed length 43.3125”