TREND R/STAND/A Manuals

t o o l t e c h n o l o g y R/STAND/A EN Original Instructions P.1 P.5 P.9 P.13 P.17 P.21 P.25 P.29 DE Übersetzung Der Originalanleitung FR Traduction Des Instructions Originales NL Vertaling Van De Originele Instructies Oversættelse Af De Originale Instruktioner DK SE Översättning Av De Ursprungliga Instruktionerna NO Oversettelse Av De Originale Instruksjonene FI Alkuperäisten Ohjeiden Suomennos R/STAND/A EN - ADJUSTABLE BENCH TOP ROLLER STAND Dear Customer, Thank you for purchasing this Trend product, which should give lasting performance if used in accordance with these instructions. TECHNICAL DATA Body size 260mm x 130mm Roller size 25mm diameter x 250mm Height adjustment 50mm to 160mm Maximum load 62kg Weight 2kg The following symbols are used throughout this manual. Denotes risk of personal injury, loss of life or damage to the tool in case of non-observance of the instructions. Refer to the instruction manual of your power tool. This unit must not be put into service until it has been established that the power tool to be connected to this unit is in compliance with 2006/42/EC (identified by the CE marking on the power tool). INTENDED USE This adjustable roller is intended for use with mitre saws mounted on a bench or other flat surface to support lengths of material. SAFETY Please read and understand the safety points in these instructions as well as you power tool instructions. PLEASE KEEP THESE INSTRUCTIONS IN A SAFE PLACE Keep fingers away from the roller and raising mechanism. Please do not modify the product. Ensure stand is on a flat surface. Safety Points 1. Disconnect power tool attachment from power supply when not in use, before servicing, when making adjustments and when changing accessories such as cutters. Ensure switch is in “off” position and cutter has stopped rotating. 2. Read and understand instructions supplied with power tool, attachment and cutter. 3. Current Personal Protective Equipment (PPE) for eye, ear and respiratory protection must be worn. Keep hands, hair and clothes clear of the cutter. 4. Before each use check cutter is sharp and free from damage. Do not use if cutter is dull, broken or cracked or if any damage is noticeable or suspected. 5. The maximum speed (nmax) marked on tool or in instructions or on packaging shall not be exceeded. Where stated, the speed range should be adhered to. 6. Insert the shank into the router collet at least all the way to the marked line indicated on the shank. This ensures at least ¾ of the shank length is held in collet. Ensure clamping surfaces are clean. -1- English