Trotec TDS DSP Manuals

TRT-BA-TDPDSP-TC2019-61-002-EN TDS DSP EN OPERATING MANUAL PRESSURE SWITCH 2 EN pressure switch TDS DSP Table of contents Notes regarding the operating manual................................. 2 Safety..................................................................................... 2 Information about the device................................................ 5 Transport and storage........................................................... 6 Assembly and installation..................................................... 6 Operation ............................................................................... 8 Errors and faults.................................................................... 9 Maintenance .......................................................................... 9 Technical annex................................................................... 10 Disposal ............................................................................... 10 Notes regarding the operating manual Symbols Warning of electrical voltage This symbol indicates dangers to the life and health of persons due to electrical voltage. Warning This signal word indicates a hazard with an average risk level which, if not avoided, can result in serious injury or death. Caution This signal word indicates a hazard with a low risk level which, if not avoided, can result in minor or moderate injury. Note This signal word indicates important information (e.g. material damage), but does not indicate hazards. Info Information marked with this symbol helps you to carry out your tasks quickly and safely. Follow the manual Information marked with this symbol indicates that the operating manual must be observed. You can download the current version of the operating manual and the EU declaration of conformity via the following link: TDP DSP https://hub.trotec.com/?id=44132 Safety Read this manual carefully before starting or using the device. Always store the manual in the immediate vicinity of the device or its site of use! Warning Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and / or serious injury. Save all warnings and instructions for future reference. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. General safety • Do not use the device in potentially explosive rooms. • Do not use the device in aggressive atmosphere. • Check accessories and connection parts for possible damage prior to every use of the device. Do not use any defective devices or device parts. • Before carrying out maintenance, care or repair work on the device, remove the mains plug from the mains socket. Hold onto the mains plug while doing so. • Do not remove any safety signs, stickers or labels from the device. Keep all safety signs, stickers and labels in legible condition. EN 3 pressure switch TDS DSP General safety warnings – Electrical safety • The device is to be supplied with a rated residual current of no more than 30 mA by means of an RCD (Residual Current protective Device). • Ensure that all electric cables outside of the device are protected from damage (e.g. caused by animals). Never use the device if electric cables or the power connection are damaged! • The electrical connection must correspond to the specifications in chapter Technical data. • Insert the mains plug into a properly secured mains socket. • Do not under any circumstances use the device if you detect damages on the mains plug or power cable. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Defective power cables pose a serious health risk! • Should the connection line of the device be damaged, it must be replaced by the manufacturer, his customer service or similarly qualified personnel in order to avoid hazards. • Should there be a risk of flooding, install the plug connections in a flood-proof area. There is a risk of electric shock! • Make sure that the mains voltage corresponds to the specifications on the nameplate. • Have all electrical installations carried out by an expert according to the national regulations and the device- specific requirements. • Hold onto the mains plug while pulling the power cable out of the mains socket. • Protect the power supply cable against heat, oil and sharp edges. Make sure that the power supply cable is not crushed, kinked or subjected to other mechanical stresses. • Only use splash-proof extension cables intended for outdoor use whilst observing the device's power input. Before using cable drums, always unroll the cable completely. Check the cable for damage. The use of extension cables which are not approved for outdoor use can result in injuries due to electric shock. • Before performing any work on the device, in case of leaks in the water system, before taking work breaks or when not in use, remove the mains plug from the mains socket. General safety warnings – Personal safety • Never insert any objects or limbs into the device. • This appliance is not a toy! Keep away from children and animals. Do not leave the device unattended during operation. Warning Device-specific safety warnings for pressure switches • Before taking the device into operation, have the following checked by an expert: – Earthing, neutral conductor and RCD must be functioning properly and correspond to the national regulations, – electrical plug connections must be protected from moisture. • Provide appropriate frost protection. • Never operate the device in the rain. Keep the device away from environmental influences such as wet conditions or frost. In particular, keep the electrical connections dry and make sure they are located in a flood-proof area. • Do not use the device at freezing temperatures or temperatures above 60 °C. • Do not use the device for drinking water supply, and do not integrate it into the drinking water circuit. In addition, please observe the local regulations of the water and wastewater authorities. Intended use The device serves for switching a connected garden or deep well pump on and off. It is used to pump rainwater or service water into private areas (e.g. into the garden) in compliance with the regulations specified in the technical data. It is installed in the water line between a pump and one or more extraction points. From there, it activates or deactivates the connected pump depending on the present water pressure and the flow rate volume. Clean fresh water is permitted as pump water (e.g. rainwater from a cistern or ground water from a private well). The temperature of the pumped water must not exceed 60° C.