Uplift Desk UPL021 Manuals

UPLIFT Desk • 1-800-349-3839 • [email protected] • www.upliftdesk.com Step 3 Insert the Dual arm adapter into the Clamp. Insert the two Gas arms into the Dual arm adapter. Insert both Horizontal arms into each Gas arm. Step 4 Place monitors face down on a flat surface, making sure not to scratch your monitor screens. Attach the Vesa mounts to the back of each monitor using a Phillips screwdriver and the eight (8) Screws provided. The mount is designed to fit the industry standard VESA 75mm & 100mm hole patterns. Step 1 Attach the Clamp to your desktop by placing the washer at the top of the Clamp’s bolt, and sliding it onto your desktop. Using the 6.5mm Allen wrench, tighten the bolt until it is secure. ® Dual Monitor Arm UPL021 Clamp 4mm Allen wrench 6.5mm Allen wrench 13mm Flat wrench Screws (qty 8) Wire clips (qty 6) Washer Vesa mount (qty 2) Horizontal arm (qty 2) 3mm Allen wrench 6mm Allen wrench Package Contents: Gas arm (qty 2) Dual arm adapter UPL121/R02 min thickness 1.25’’ max thickness 3.5’’ fig. 1 fig. 2 fig. 3 Step 2 (optional) If the Clamp does not fit on your desk, you can adjust the clamp. Unscrew the two bolts and remove the lower clamp from the main Clamp assembly, and unscrew the bolt (see figure 1). For the minimum size, reassemble the clamp as shown in Figure 2. This will fit desks 1.25’’ thick. For the maximum size, reassemble the clamp as shown in Fig- ure 3. This will fit desks up to 3.5’’ thick. Once the Clamp has been set up to fit your thicker desktop, perform the actions in Step 1 above.