Vestamatic VRS SMT 01580011 Manuals

Subject to modifications. © Vestamatic GmbH Art.-Nr.: 85601421 F1 • Vestamatic GmbH • Dohrweg 27 • D-41066 Mönchengladbach • www.vestamatic.com 1/2 G VRS SMT Light Receiver VRS FMT Light Receiver Art. no.: 01580010 / 01580011 Installation and Operating Instructions VRS SMT Light Receiver Art. no.: 01580010 VRS FMT Light Receiver Art. no.: 01580011 VRS radio receiver to connect a light source in SMT or FMT Housing. Short description � Radio receiver for control a light source � Operation via all hand and wall transmitters of the Vestamatic Radio System (VRS) Safety precautions – Contact a professional electrician to install the control sys- tem, because the control system requires a power supply of 230VAC, 50 Hz. – Check the control system for signs of mechanical damage after unpacking. If you notice any shipping damage, do not start up the control system and notify your supplier immedi- ately. – The control system should only be used for the purpose speci– fied by the manufacturer (refer to the operating instructions). Any changes or modifications thereof are not permissible and will result in loss of all warranty claims. – If the control units or the connected sunshade cannot be oper- ated without presenting a hazard, it must be switched off and prevented from being switched on unintentionally. Table of loads Type of load Max. load Resistive load: Light bulbs 230VAC, Halogen lamps etc. 10 A / 2300 VA Inductive load: Halogen lamps with wound transformers Fluorescent lamps (series) Fluorescent lamps (parallel) 2.6 A / 600 VA 10 A / 2300 VA 2.6 A / 600 VA Capacity EB: Electronic ballasts, electronic transformers etc. 4 A / 920 VA Technical data Power supply: 230VAC, 50 Hz Power consumption: 35 mA Radio frequency: 868 MHz Protection degree: IP 40 (FMT); IP 54 (SMT) IP class: II Operating temperature: -20 °C (-4 °F) to +60 °C (140 °F) Dimensions (L × W × H): 46 × 46 × 25 mm Conformity: p Functional description The radio receiver is used for switching mains powered devices in the operating modes ON / OFF and Timer. The receiver can be operated by hand and wall transmitter of Vestamatic radio system (VRS). Assembly and installation WARNING! Risk of injury due to improper installation and commissioning. Improper installation and commissioning may lead to per- sonal injury or property damage. Therefore: – When connecting the device, observe the currently valid VDE standards (in particular DIN VDE 0100/0700), your local power company’s regulations and the current accident prevention regulations. – Connect the control in accordance with the wiring diagram. Notes for professional electricians 1. Switch off the control power supply. 2. Connect the cables in accordance with the wiring diagram. 3. Mount the receiver on a suitable mounting location (see chapter “Instructions for radio receiver”). 4. Switch on the power supply. 5. After connecting the receiver is in operation mode. The LED is off. 6. Transfer the codes of the transmitters to the receiver (see section “programming a radio transmitter”). Wiring diagram