Vista 5237 Manuals

INSTALLATION INSTRUCTIONS Up and Accent Lights FOR USE ONLY WITH LOW VOLTAGE LANDSCAPE POWER UNITS THAT DO NOT EXCEED 25 AMPS, 15 VOLT MAXIMUM. WARNING: Luminaires must be installed in accordance with the National Electrical Code (NEC) and local codes. Failure to do so will void the warranty and may result in serious injury and/or damage to the luminaire. SAFETY WARNING: Luminaire can become very hot depending on lamp wattage used. Lens and metal around lamp can become hot enough to blister hands. Particular care should be taken not to locate luminaires where small children can reach them if high wattage lamps are used. SUBJECT TO LOCAL CODE, WHICH IS GOVERNING, LUMINAIRES ARE NOT TO BE INSTALLED WITHIN 10 FT. (3.05M) OF A POOL OR SPA. SECONDARY CABLE IS NOT TO BE BURIED MORE THAN 6”. WHEN USING MULTIPLE LUMINAIRES, LOAD IS NOT TO EXCEED THE TOTAL WATTS OF TRANSFORMER RATING. DO NOT USE EXTENSION CORDS ON POWER UNITS. NOTE: Always use UL recognized wire connectors for connections. NOTE: Save these instructions for future reference. LUMINAIRE IS UL LISTED FOR ABOVE GROUND INSTALLATION ONLY. LUMINAIRE MOUNTING (with ground stake): 1. To prevent electrical shock, disconnect transformer from electrical supply before installation or service. 2. Run wire pigtail from luminaire through the mounting hole in top of ground stake. 3. Thread luminaire into threaded hole in ground stake. 4. Place stake in desired position and insert into ground until flange of stake is flush to grade. 5. Strip the (2) leads from the luminaire pigtail wire. Using the two (2) silicone filled safety connectors (provided), connect the leads from the luminaire to the main supply cable leads. NOTE: Luminaires are supplied with 36” of 18-2 cable pigtail for secure connection to the main supply cable. The wire is to be protected by routing in close proximity to the luminaire. The wiring should be buried a maximum depth of 6 inches (15.2 cm) in order to connect to the main supply cable. 6. Aim luminaire to desired angle. Lock into place by tightening phillips screw in adjustable knuckle. NOTE: Avoid aiming fixture directly upward. Whenever possible, set at angle to prevent rain or irrigation water from settling on lens. 1625 Surveyor Avenue • Simi Valley, CA 93063 • (805) 527-0987 • (800) 766-VISTA (8478) FAX: (888) 670-VISTA (8478) • [email protected] • www.vistapro.com 12V SERIES 5237