WAREMA WMS Weather Station Eco Manuals

Operating and installation instructions WAREMA Mobile system WMS Weather station eco Keep for future use! Valid from 1 January 2020 2024730_d•en•2020-01-01 We reserve the right to make technical modifications 1 CAUTION Never press buttons on your transmitter arbi- trarily without line of sight to the sun shad- ing product. Children may not play with this product – keep remote controls and trans- mitters out of the reach of children! NOTICE The receiver (e.g. the radio plug receiver, radio tubular motor) cannot function in the event of a power failure. Therefore, raise the sun shading system early enough in case of an approaching storm. Due to both legal regulations for radio systems and struc- tural factors, the operating range of radio remote controls is limited. Sufficient radio reception must be ensured when planning the project. This is especially the case where the radio signal must pass through walls and ceilings. The control unit should not be installed in the immediate vicin- ity of metal components (steel beams, reinforced concrete, fire doors). Therefore, check that the receiver is functioning prop- erly before the final installation. Strong local transmitter systems (e.g. WLAN) with trans- mission frequencies identical to those of the control system may interfere with reception. Installation This device is designed for surface mounting on a build- ing facade. It can also be mounted on a pole using the included cable ties. Included fixing materials: � 2 screws 4.5 x 40 mm � 2 screw anchors 6 mm � 2 spacers for wall and ceiling installation (Fig. 2) � 2 steel cable ties 360 mm Use suitable fixing materials only. Depending on the sub- structure (e.g. plastered outer insulation), other screws and screw anchors may need to be used. Important information on the installation loca- tion Attach the device outdoors at a readily accessible but raised location. Metal-clad buildings, domestic interference sources (unshielded household appliances, television sets, computers), supply lines and metallic objects such as sheet metal enclosures must have a distance of at least 0.5 m from the weather station. General information 1 4 2 3 5 Fig. 1 WMS weather station eco 1 Solar panel 2 Photodiodes 3 Wind wheel 4 Joint 5 Mounting plate with cover Three storage batteries for the power supply are found under the cover. The WMS Weather station eco enables the wireless control of sun shading drives and is equipped with sensors for brightness and wind speed. The station is solar powered. The device transmits weather data to WMS-compatible receivers. Intended use The WMS Weather station eco is an electronic device to control WMS receivers. Any use other than the purpose described in these instructions requires approval from the manufacturer. Safety instructions WARNING An automatically controlled mechanism may begin to move unexpectedly! Therefore, never place any objects in the area of move- ment of an automatically controlled mechanism. Disconnect the power supply of the controlled sun shading products before maintaining or cleaning the products.