Watermark SS-TH60 Manuals

INSTALLTION FOR MINIATURE THERMOSTATIC VALVE Rev. 8/19 P a g e | 1 SS-TH60 – 1/2” MINIATURE THERMOSTATIC VALVE WITH VOLUME CONTROL SS-TH70 – 1/2" MINIATURE THERMOSTATIC VALVE WITH 2-WAY DIVERTER SS-TH80 – 1/2" MINIATURE THERMOSTATIC VALVE WITH 3-WAY DIVERTER Features: • Ability to pre-select water temperature – thus conserving water • Compensates for water pressure fluctuations preventing scalding • Safety button at 100°F prevents accidental scalding • High flow rates allow for multiple shower applications Specifications: o Operating pressure is 20 PSI to 85 PSI o When pressure is higher than 85 PSI a pressure reducer (fitted before the valve) is required. o Temperature range is 60°F to 115°F o Recommended supply setting is 45 PSI and 150°F Note: • DO NOT USE PLUMBER’S PUTTY ON ANY OF THE BRASS COMPONENTS This will cause the finish to tarnish and void the warranty. A non-corrosive Alkoxy Silicone is recommended. • DURING SWEATING OF LINES DO NOT OVERHEAT CASTING Overheating may cause damage to internal mechanism and void the manufacturer’s warranty as well as increase the risk of scalding. • COPPER ADAPTORS MAY BE REQUIRED TO COMPLETE YOUR INSTALLATION • Shipping weight (lbs.): 4 • Shipping dimension (in.): 8 x 11 x 5 Diagram 1: Flow Rate Vs. Pressure SS-TH60 SS-TH70/80 Valve Installation 1. Flush the lines of all dirt and debris. Failure to completely flush the lines will cause valve failure and will void the manufacturer’s warranty. 2. Fit the valve on the wall without removing the plastic cover on the control spindle. Turning the control spindle will change the temperature setting which is pre-calibrated at the factory. 3. Connect the hot water supply to the left inlet of the valve (hot marked with “H”) and cold supply to the right inlet (cold marked with “C”).