WB Manufacturing Study Carrel Starter Kit Manuals

1 wibenchmfg.com 507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303 Step 1: • Attach (2) 4” L-brackets to the inner side of the left leg aligning them with the pre-drilled holes using #10x3/4” square pan screws. Tighten with a #2 square drive screw driver or a #2 square bit with a screw gun. Repeat this step for the right leg. Step 2: • Attach (1) 4” L-bracket to the inner side of the modesty panel aligning it with the pre-drilled holes using #10x3/4” square pan screws. Tighten with a #2 square drive screw driver or a #2 square bit with a screw gun. Step 3: • Align connectors on the left and right ends of the modesty panel with the connectors on the left and right legs. Press down until it’s fully engaged. (This is the step where it would be helpful to have three people; one person per leg holding them in place and one person pressing down the modesty panel into the connectors located on the left and right legs.) • NOTE: If you are assembling an Adder Kit along with this Starter Kit, you will need to replace the right leg with the center leg. The right leg will be the very last one to be attached. Step 4: • Place top face down on a protected surface so pre-drilled holes are facing up. Attach cord channel to top aligning it with the pre-drilled holes using #10x3/4” square pan screws. Tighten with a #2 square drive screw driver or a #2 square bit with a screw gun. V041819 subject to change. Study Carrel Starter Kit Step 1 Modesty panel Left leg Step 2 Step 4 Step 3 Modesty panel Connectors Left leg Right leg Assembly Instructions Before you begin, please make sure all parts and proper quantities are included. (See Part Identifier Key) Any parts damaged during shipment must be reported within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303. Assembling this unit on Step 3 may take up to three people to help hold both left/right legs and another to assemble the modesty panels.