WHITE MARQUEE FANMASTER Manuals

FANMASTER HEATER INFORMATION SHEET General Information The Fanmaster is an industrial air heater specifically designed for use in well ventilated indoor areas. The unit runs on a 8.5kg propane gas cylinder. Operating Instructions TO START AND USE 1. Plug in the mains lead to a wall socket. 2. Press the ON-OFF switch on. Let the motor fan run at least 230 seconds to check if the fan works properly and/or to purge any fuel gas left from the last use. 3. With the hose attached to the gas inlet open the gas valve on the cylinder slowly. Be sure there is no gas leakage. 4. Push in and hold the safety start valve button. Push ignition button repeatedly until the burner lights. If the heater does not light within 10 seconds, wait a minimum of 3 minutes before retrying the correct ignition circuit. 5. After the burner lights, keep the safety start valve button depressed for at least 5 seconds then slowly release and the heater will continue to operate. SAFETY • Keep area clean and well lit. • Keep children and bystanders away whilst operating the heater. • Do not expose heaters to rain or wet conditions • Do not spray aerosols in the vicinity of the heater. • Do not place articles on or against the heater. • Not for domestic use. • Use ONLY in well ventilated areas. • Gas cylinder to be place on the side of the heater unit, NOT in front or behind. • Be sure that the heater is only used with the correct ventilation. Make sure that no object may obstruct the fan air intake. TROUBLESHOOTING PROBLEM CAUSE REMEDY Fan doesn’t work. 1. No electricity. 2. Blade stalled by housing. 1. Check power Supply 2. Call White Marquee Piezo will no ignite. 1. Ignition cable damaged. 2. Ignition cable disconnected. 3. Distance between electrode and burner too large. 1. Call White Marquee 2. Call White Marquee 3. Adjust distance within 3-8min No gas. 1. Gas cylinder is empty. 2. Gas valve on cylinder closed. 3. Gas valve of heater not open. 1. Replace new gas cylinder. 2. Open the valve. 3. Attempt re-light sequence correctly. Flame goes out while heater is running. 1. Thermo-element was not heated enough. 2. Safety thermostat activated. 3. Restricted air flow. 1. Repeat ignition process and keep safety gas valve depressed for a minimum of 5 seconds, then release slowly. 2. Allow the heater to cool down for at least 10 minutes. Check thermostat and the attempt re-light sequence correctly. 3. Check heater inlet and outlet, remove any obstructions. SPECIFICATIONS Rated voltage 220V-240V-50H Rated output 80W Heat output 70Mj/hr Air flow 500m3/h Gas consumption 1.42kg/h. Weight (approx.) 8.5kg Min gas cylinder size 15kg Minimum volume of room 360m3