Yakima HoldUp Evo Manuals

2 pdf manual(s) Yakima HoldUp Evo for free download (Document Types: Installation instructions manual, Manual )

Yakima HoldUp Evo Installation instructions manual [PDF] (8 pages)

  • Identifier: id-1632329
  • Brand: Yakima
  • Device: HoldUp Evo Racks & Stands
  • Type: PDF
  • Key Aspects: Best Practices for Everyday Use, Unpacking and Inspection Guidelines, Control Panel and Interface Navigation
  • UPD Date: 01.08.2026
  • Source File: 1686400.pdf
  • Pages: 8
  • Description: Installation instructions for the Yakima HoldUp Evo.
Pages Preview:
  • ,167$//$7,21 ALIGN t Insert tongue into hitch receiver. t The hole in the base must align to the hole in the hitch receiver. 1 A B C 2 3 A. Insert the safety pin. B. Tighten the knob COMPLETELY while wiggling the tongue. C. Lock the knob (when locked, the knob will turn freely). Tip: Use a permanent marker to draw a line on the tongue, so that you know how far to insert the tongue next time you install your carrier. Affix the spacers to the base as sho
  • 5 6 Install the spine bolt, washers, and nut. You may need to wiggle the spine to get the bolt to pass through. Then fully tighten using the provided wrenches. Remove the attachment hardware from the tray assemblies. A B C D B 8X 34 Nm (25 ft-lbs) 7 A. Place the the lower tray assembly into position. It's the assembly with the large Yakima sticker. Orient the tray so that the sticker is right side up. B. Install the hardware and fully tighten to 17 ft-lbs
  • 3 Fold down the hook arms. 2 a t Tuck wheelstraps under wheel cup. t Load your heaviest bike first. t Always load the first bike closest to the vehicle. “click” 1 b Depress the tilt lever with your foot, and fold down the carrier. Note: Carrier can fold down past horizontal to aid in loading your bikes. Be TVSFUPSFUVSOUIFDBSSJFS UPUIFMPDLFEIPSJ[POUBM QPTJUJPOBGUFSMPBEJOH CAUTION: *GBGFOEFSQSFWFOUTQSPQFS QMBDFNFOUPGUIFXIFFMIPPL
  • 4 7 > Rotate the pivot arm up until the hook rests on the bike tire 1” or less from the brakes or the fork. Failure to place wheel hook in the correct position can cause your bicycle to eject, and cause personal injury, property damage, or death. Feed the strap through the spokes of wheel. Rotate the wheel slightly, if necessary, and avoid the valve stem. Insert the strap end through the buckle. Pull to tighten. Compress the hook against the wheel by app
Document Preview & Text Transcription (Main Page)
Click to expand and read text
$POUFOUT tongue (1X) wrench 2X washer (2X) nut (1X) spine bolt (1X) Key (2X) spine (1X) spacer (2X) front tray assembly (1X) rear tray assembly (1X) tray bolt (4X) tray bolt (4X) washer (4X) washer (4X) lock washer (4X) lock washer (4X) HoldUp Evo 8FJHIUMJNJUT Per Bike = 50lbs. / 22.7kg "WBJMBCMFBDDFTTPSJFT #8002482 HoldUp EVO +2 (Works only with 2” Hitches)

Yakima HoldUp Evo Manual  [PDF] (8 pages)

  • Identifier: id-1461338
  • Brand: Yakima
  • Device: HoldUp Evo Racks & Stands
  • Type: PDF
  • Key Aspects: Cleaning and Sanitization Methods, Product Performance Metrics, Documentation and Revision History
  • UPD Date: 27.08.2026
  • Source File: 1537103.pdf
  • Pages: 8
  • Description: User operation guide for the Yakima HoldUp Evo.
Pages Preview:
  • Instruction #1035898D-2/8 ,167$//$7,21‡0217$*(‡,167$/$&,Ð1 ALIGN ALIGNER ALINEAR t Insert tongue into hitch receiver. t The hole in the base must align to the hole in the hitch receiver. t Introduzca la espiga de la base en el receptor del enganche. t El agujero de la espiga de la base debe quedar alineado con el del receptor del enganche. t Enfiler le timon dans l’attelage. t Le trou du timon doit s’aligner avec le trou de l’attelage.
  • Instruction #1035898D-3/8 5 6 Install the spine bolt, washers, and nut. You may need to wiggle the spine to get the bolt to pass through. Then fully tighten using the provided wrenches. Poser le boulon, les rondelles et l’écrou. Il faudra probablement remuer la poutrelle pour que le boulon s’enfile. Ensuite, serrer complètement à l’aide des clés fournies. Instale el perno, las arandelas y la tuerca del soporte reclinable. Es posible que deba mov
  • Instruction #1035898D-4/8 3 Gire los brazos pivotantes hacia abajo. Abaisser les bras pivotants. Fold down the hook arms. 2 a t Tuck wheelstraps under wheel cup. t Load your heaviest bike first. t Always load the first bike closest to the vehicle. t Caler la sangle de roue sous le support de roue. t Charger le vélo le plus lourd en premier. t Toujours charger le premier vélo le plus près du véhicule. t Pliegue las correas de rueda debajo de lo
  • Instruction #1035898D-5/8 4 7 > Rotate the pivot arm up until the hook rests on the bike tire 1” or less from the brakes or the fork. Failure to place wheel hook in the correct position can cause your bicycle to eject, and cause personal injury, property damage, or death. Redresser le bras pivotant de manière que le crochet porte sur le pneu à 2,5 cm (1 po) ou moins du frein ou de la fourche. Si l'on ne plaçait pas le crochet correctement, le vélo po
Document Preview & Text Transcription (Main Page)
Click to expand and read text
Instruction #1035898D-1/8 $POUFOUTt$POUFOVt$POUFOJEP tongue (1X) timon (x 1) base (1X) wrench 2X clé (x 2) llave 2X washer (2X) rondelle (1X) arandela (1X) nut (1X) écrou (1X) tuerca (1X) spine bolt (1X) boulon de poutrelle (1X) perno de la base (1X) Key (2X) clé (x 2) llave (2X) spine (1X) poutrelle (x 1) soporte reclinable (2X) spacer (2X) entretoise (x 2) espaciador (2X) front tray assembly (1X) plateau avant (X 1) soporte de ruedas delantero (1X) rear tray assembly (1X) plateau arrière (X 1) soporte de ruedas trasero (1X) tray bolt (4X) boulon de plateau (x 4) perno de la bandeja (4X) tray bolt (4X) boulon de plateau (x 4) perno de la bandeja (4X) washer (4X) rondelle (x 4) arandela (4X) washer (4X) rondelle (x 4) arandela (4X) lock washer (4X) rondelle de sécurité (x 4) arandela de cierre (4X) lock washer (4X) rondelle de sécurité (x 4) arandela de cierre (4X) HoldUp Evo 8FJHIUMJNJUT -JNJUFTEFDIBSHFNFOUt-ÓNJUFTEFQFTP 50lbs. / 22.7kg Per Bike = 50lbs. / 22.7kg Por bicicleta = 22.7kg / 50 lbs. Par vélo = "WBJMBCMFBDDFTTPSJFT "DDFTTPJSFTEJTQPOJCMFTt"DDFTPSJPTEJTQPOJCMFT #8002482 HoldUp EVO +2 (Works only with 2” Hitches) (Seulement pour les attelages de 5,1 cm/2 po) (compatible solamente con enganches de 2")

Yakima HoldUp Evo: Racks & Stands Category Related Instructions

STS8001/00
Philips STS8001/00
28.04.2026 1 pages

Device operation guide for the Philips STS8001/00 Home Theater System. The guide focuses on wiring setup, operational safety, installation procedures, product safety.

32-inch Partial End Closure
Wenger 32-inch Partial End Closure
22.06.2026 10 pages

Owner’s Manual High Density Sports Storage Partial End Closure Accessory 32-inch Partial End Closure 48-inch Partial End Closure ©Wenger Corporation 2005 Printed in USA 02/05 Part #240A089-1 Wenger Corporation, 555 Park Drive, P.O. Box 448, Owatonna, Minnes User instruction booklet for the Wenger 32-inch Partial End Closure Racks & Stands. The document includes dimensions and layout, cleaning instructions, setup tips, control functions.

ICA-LCD 109
Techly ICA-LCD 109
31.05.2026 8 pages

P/N: ICA-LCD 109 8057685301207 standard vesa 200x100 MAX Technical features 23 51 lb hardware included easy installation LED 100 SILVER Color LED LCD TV universal WALL MOUNT 13” 31” 33 79 cm WWW.TECHLY.COM +18° -25° Wall distance 5,5 cm EN IT DE FR ES Maintenance and service manual for the Techly ICA-LCD 109 Racks & Stands. The document offers guidance on operating instructions, network setup, setup instructions, installation procedures.

Precision 7920
Dell Precision 7920
15.06.2026 133 pages

Dell Precision 7920 Rack Owner's Manual Regulatory Model: E38S Regulatory Type: E38S001 November 2020 Rev. A02 User operation guide for the Dell Precision 7920 Racks & Stands. The document covers testing procedures, security instructions, device instructions.