-
READ THIS MANUAL CAREFULLY!
1
-
IMPORTANT MANUAL INFORMATION
4
-
Indicates a potential hazard that could
6
-
PRE-OPERATION CHECKS ........... 5-1
7
-
PERIODIC MAINTENANCE AND
8
-
Headlight beam adjustment.......... 8-58
9
-
1-LOCATION OF THE WARNING AND
10
-
Read and understand all of the labels on your
11
-
EE.book Page 4 Friday, May 6, 2005 2:55 PM
13
-
Improper handling of gasoline.
18
-
Starting or running the engine in a
19
-
1-DESCRIPTION AND MACHINE IDENTIFICATION
20
-
Identification number records
21
-
Vehicle identification number
22
-
Indicator and warning lights
24
-
G The engine may overheat if the ATV is
25
-
Coolant temperature warning light checking method
26
-
Reverse indicator light “R”
27
-
The speedometer shows riding speed. This
28
-
1. Light switch “
29
-
Start switch “
30
-
Changing from 2WD to 4WD or from
31
-
Once the engine is running, movement of the
32
-
The speed limiter keeps the throttle from fully
33
-
Front brake lever
34
-
Drive select lever
35
-
Fuel tank cap
36
-
The fuel cock supplies fuel from the fuel tank
37
-
1. Arrow mark pointing to “RES”
38
-
To remove the seat, pull the seat lock lever
39
-
The storage compartment is located under
40
-
1. Storage compartment
41
-
1. Spring preload adjusting ring
42
-
Auxiliary DC jack
43
-
4. When the auxiliary DC jack is not being
44
-
Front and rear brakes
46
-
Brake fluid leakage
47
-
Make sure there is sufficient gasoline in the
48
-
There are two types of gasohol; gasohol con-
49
-
Make sure the engine oil is at the specified
50
-
Differential gear oil
51
-
Check the coolant level in the coolant reser-
52
-
Check to see that the throttle lever operates
53
-
Operating this ATV with improper tires,
54
-
4. Use no more than the following
55
-
How to measure tire pressure
56
-
Tire wear limit
57
-
G When the drive select lever is in the neu-
59
-
G If the engine fails to start, release the
60
-
Drive select lever operation and reverse
61
-
Shifting: Neutral to Reverse and Reverse
62
-
5. Open the throttle lever gradually and con-
63
-
There is never a more important period in the
64
-
Avoid prolonged operation above 3/4 throttle.
65
-
Parking on a slope
66
-
Accessories and loading
67
-
Cargo or a trailer can change the stability and
68
-
G Ride more slowly than you would without a
69
-
EE.book Page 1 Friday, May 6, 2005 2:55 PM
71
-
RIDE WITH CARE AND GOOD
73
-
Not recommended for children under
74
-
This ATV is designed to carry operator and
75
-
Operating this ATV without wearing an
76
-
Do not operate after consuming alcohol or
77
-
Always perform the pre-operation checks list-
78
-
Loading and accessories
80
-
Always keep your feet on the footboards dur-
81
-
Avoid wheelies and jumping. You may lose
82
-
Operating this ATV with improper modi-
83
-
The exhaust system on the ATV is very hot
84
-
BE CAREFUL WHERE YOU RIDE
85
-
Do not ride on any public road, street, or high-
86
-
Know the terrain where you ride. Ride cau-
87
-
Failure to use extra care when operating
88
-
When riding in an area where you might not
89
-
Select a large, flat area off-road to become fa-
90
-
TURNING YOUR ATV
91
-
This procedure should be practiced at slow
92
-
Use proper riding techniques to avoid vehicle
93
-
Climbing hills improperly.
94
-
If you are climbing a hill and you find that you
95
-
When crossing the side of a hill:
96
-
If your ATV has stalled or stopped and you
97
-
If you begin rolling backwards:
98
-
When riding your ATV downhill, shift your
99
-
Going down a hill improperly.
100
-
CROSSING A SLOPE
101
-
EE.book Page 33 Friday, May 6, 2005 2:55 PM
102
-
CROSSING THROUGH SHALLOW WATER
103
-
Test your brakes after leaving the water. Do
104
-
RIDING OVER ROUGH TERRAIN
106
-
SLIDING AND SKIDDING
107
-
With practice, over a period of time, skill at
108
-
WHAT TO DO IF ...
109
-
G If your ATV is traversing a sloping surface:
110
-
1-PERIODIC MAINTENANCE AND
111
-
The service information included in this man-
112
-
General maintenance and lubrication chart
114
-
G Recommended brake fluid: DOT 4
115
-
Panel removal and installation
116
-
Panel A, D
117
-
1. Place the panel in its original position.
118
-
Remove the bolt, and then take the panel off.
119
-
1. Bolt (× 2) (under fenders)
120
-
Remove the bolts, and then take the panel off.
121
-
Place the panel in its original position.
122
-
5. Remove the engine oil filler cap and wipe
123
-
8. Insert the dipstick into the oil filler hole,
124
-
Skip steps 5–9 if the oil filter cartridge is not
125
-
8. Install the new oil filter cartridge with an
126
-
10. Install the engine oil drain bolt, and then
127
-
Final gear oil
128
-
Changing the final gear oil
129
-
6. Add the recommended final gear oil to
130
-
Differential gear oil replacement
131
-
5. Fill the differential gear case with the
132
-
1. Place the ATV on a level surface.
133
-
Hard water or salt water is harmful to the
134
-
1. Radiator cap
136
-
11. Install the coolant reservoir hose.
137
-
Check the protective boots for holes or tears.
138
-
Spark plug inspection
139
-
Instead, take the ATV to a Yamaha dealer.
140
-
If a torque wrench is not available when you
141
-
1. Fastener (× 4)
142
-
6. Squeeze the excess solvent out of the air
143
-
The air filter element should be cleaned every
144
-
V-belt case drain plug
145
-
1. Spark arrester
146
-
The carburetor is a vital part of the engine and
147
-
1. Throttle stop screw
148
-
Select lever safety system cable
149
-
Rear brake pad check
150
-
Inspecting the brake fluid level
151
-
Observe these precautions:
152
-
Brake fluid replacement
153
-
Adjusting the rear brake lever and brake
154
-
If correct free play cannot be obtained, ask a
155
-
Operating with improperly serviced or
156
-
Adjusting the rear brake light switch
157
-
Cable inspection and lubrication
158
-
Rear knuckle upper and lower pivot
159
-
1. Loosen the wheel nuts.
160
-
1. Tapered nut
161
-
Do not try to remove the sealing caps of
162
-
1. When the machine is not used for a
163
-
1. Main fuse
164
-
To prevent accidental short-circuiting,
165
-
2. Disconnect the headlight coupler by lift-
166
-
4. Install a new headlight bulb holder as-
167
-
5. Connect the headlight coupler.
168
-
Tail/brake light bulb replacement
169
-
1. Tail/brake light bulb holder
170
-
Although Yamaha machines receive a rigid in-
171
-
Starting problems or poor engine performance
172
-
If it i diffi
173
-
1-CLEANING AND STORAGE
174
-
6. Clean the seat with a vinyl upholstery
175
-
Long term storage (60 days or more) of your
176
-
7. Remove the battery and charge it. Store
177
-
1,993 mm (78.5 in)
178
-
Recommended engine oil classification:
179
-
Final gear case oil:
180
-
DR8EA / NGK
181
-
Dual disc brake
182
-
Bulb voltage, wattage × quantity:
183
-
TAMPERING WITH NOISE CONTROL SYSTEM PROHIBITED:
184
-
YAMAHA MOTOR CORPORATION, U.S.A.
186
-
EE.book Page 2 Friday, May 6, 2005 2:55 PM
187
-
YAMAHA EXTENDED SERVICE (Y.E.S.)
188
-
EE.book Page 3 Friday, May 6, 2005 2:55 PM
190
