Life Fitness FIT SERIES Assembly Instructions Manual

two 3/8” SAE WASHERS (44), two 3/8” RH WASHERS (45) and one 3/8” LOW HEIGHT LOCK NUT (43) as shown in FIGURE 15. • Assemble two ROLLER PADS (28) and four 2-3/8” OD PLASTIC WASHERS (21) to the KNEE HOLD DOWN (4) using two 1-1/4” SHAFT COLLARS (25) as shown in FIGURE 15. FIGURE 15 39 3/8 X 164mm 45 44 43 47 4 6 28 21 25 ...

(47) over the RH WASHERS (45) on all tightened connections. TIGHTEN! STEP 5: TIGHTEN! 24 • Slide the 13/16” SHAFT COLLARS (24) up against the GUIDE ROD SUPPORT (12) and SECURELY tighten the set screws on the SHAFT COLLARS (24). See FIGURE 6. ...

• If upon completion of assembly, the HEAD PLATE (22) does not sit on top of the first WEIGHT PLATE (20), push the HEAD PLATE (22) down, insert the WEIGHT STACK PIN (23) and perform several repetitions. This will relax the cable system and prevent the HEAD PLATE (22) from lifting up. See FIGURE 17. • If after completing the previous step, the HEAD PLATE (22) still does not sit on top of the first WEIGHT PLATE (20) or if there is excess slack in the cab ...

four 3/8” SAE WASHERS (44), four 3/8” RH WASHERS (45) and two 3/8” LOW HEIGHT LOCK NUTS (43) as shown in FIGURE 4. FIGURE 4 8 • LOOSELY assemble the LAT/LOW BOOM (3) to the TOWER (1) and the GUIDE ROD SUPPORT (12) using two 3/8 X 73mm BOLTS (36), four 3/8” FLAT WASHERS (33) and two 3/8” LOW HEIGHT LOCK NUTS (43) as shown in FIGURE 4. 36 3/8 X 73mm 36 3/8 X 73mm 47 45 44 43 33 43 1 12 6 3 ...