Navman Lone Worker Installation Manual

2 Contents Disclaimer ....................................................................................................... 3 1 Introduction ............................................................................................... 5 1.1 Product Overview........................................................................................ 5 1.2 Audience .................................................................................................... 5 1.3 Box Contents ........................................................................ ...

4 Safety Warning - Lone Worker Pendant - Lithium Polymer Battery Your Lone Worker Pendant contains a Lithium Polymer (LiPo) rechargeable battery that provides excellent battery life and reliable use. They are widely used in many electronic products today however Lithium Polymer batteries are known to be volatile, causing explosion and fire if misused or mistreated and extra care and precautions should be taken with any product that incorporates this type of battery.  Do not expose your Pendant to extreme temperatures. If the ambient temperature ...

12 1. Push the 5-Wire Output Cable firmly onto the 5-Pin Output at the back of the Interface Module. Check that the toggle on the white connector has latched into place. 2. Connect the individual output wires at the other end of the 5-Wire Output Cable to the Qube’s I/O cable, as follows: Note – the colours shown below relate to a Qube 4 10-way connector Output Wire ConEx Qube Pin Qube Wire Colour Function 1 DI-3 6 Blue High Priority Alert (this also Wakes the Qube From Sleep), Person Down Alert, Out of Range Warning 2 DI-1 8 Green/White NOT USED ...

7 2 Installation 2.1 Prerequisites This installation process assumes that:  A Qube is already installed in the vehicle and is fully operational. If not, please install the Qube according to its install guide BEFORE starting the Lone Worker Solution installation. Note that the Lone Worker Solution is compatible with any Qube that has sufficient digital I/O available. Depending on the mode used, the Lone Worker Solution requires 2 or 4 digital inputs and 1 digital output.  The Qube already has a suitable ConEx cable installed. If not, please obtai ...