MB QUART N1-RFBT Quick Start Installation Manual

before installing any audio components. Be careful and take your time. Do not let wires make contact with metal edges or hot engine components. Congratulations on your choice of a MBQuart Bluetooth controller. This “Quick Start” Installation guide is meant to help you complete a basic installation. For more detailed information, visit our website at MBQuart.com The controller can be mounted on any fl at surface using the surface mount cradle. This will allow the controller to be removed for use in hand as well as kept in the cradle when not in use. Before drilling any holes make sure there are no obstructions behind the mounting surface. Also make sure there is enough space around the cradle to remove and replace the controller easily. The controller battery can be changed by sliding the access door downward. This method will allow the controller to sit fl ush to the mounting surface. This requires a perfectly fl at surface and ideally should have access to the rear of the mounting panel. Before drilling the mounting hole, make sure there are no obstructions behind the mounting area. The wiring and connections should be secure and away from any moving parts or extremely hot surfaces. The RCA pre amp output can be connected directly to an amplifi er. The RCA aux input can be used to connect a secondary source. The remote input wire should be connected to a switched +12V source. The remote output wire provides a +12V output to turn on an amplifi er. Flush Mounting Wiring 55mm 2.18” (2-3/16”) 35mm (1-3/8”) minimum clearance +12V (red) REMOTE OUT REMOTE IN (blue) USB Charger Status Indicator GROUND (black) PRE AMP OUT AUX IN CR2032

defects in material and workmanship for a period of one (1) year from the date of purchase. Maxxsonics USA Inc. will, at it’s discretion, repair or replace defective products during the warranty period. Components that prove to be defective in materials and workmanship under proper installation and use must be returned to the original authorized Maxxsonics USA Inc. retailer from where it was purchased. A photocopy of the original receipt must accompany the product being returned. The costs associated with removal, re-installation and freight are not the responsibility of Maxxsonics USA Inc. This warranty is limited to defective parts and specifi cally excludes any incidental or consequential damages connected therewith. To view the full warranty, please visit the website. MBQuart products are designed and engineered in the USA by 847-540-7700 www.maxxsonics.com N1-RFBT N1-RFBT Wireless Bluetooth Wireless Bluetooth® Controller Controller MBQ N1-RFBT QSG 01 - rev4 Volume UP - Each press will increase the volume. Volume DOWN - Each press will decrease the volume. Track UP - Press to advance to the next track. Track DOWN - Press to restart the current track or to back up to previous tracks. PLAY / PAUSE - Press once to pause. Press again to play. Mode - One press will toggle between Bluetooth function and the auxiliary input. Controls Bluetooth Device Pairing Auxiliary Input Volume DOWN Volume UP Track DOWN PLAY / PAUSE Track UP Mode 1 3 4 6 5 2 1 2 3 4 5 6 The pairing process can vary based on your particular device. Refer to the operating instructions of your device. Below is the general process to connect the controller. A secondary device can connected through the AUX INPUT. Pressing the MODE button will switch to this input. The status indicator will change to solid red. The status indicator will fl ash slowly when “searching” for the last paired device. If no device is located, it will fl ash quickly indicating it is ready to pair to a new device. On your Bluetooth enabled device, search for “MB QUART” under Bluetooth settings. Select MB QUART, wait for the device to indicate “connected”. The status indicator will change to solid blue. Music will now play through the system.