Nikko Stirling NSLRF501 User Manual – Operating Manual

eyepieces to make the object clearer. 3. Measuring: To measure the distance to a target, follow these steps: Result keeps Display in 10 seconds. 4. Selection of Unit of Measure: To change the Unit of Measure, hold down the MODE button for 3 seconds. The display will change between METERS and YARDS. Press POWER Button (Inner LCD got display) Measured Distance Push the Mode Button Repress POWER Button Aim Reticle at Target Choice Mode Automatic T Af operation. urns Off ter 10Sec. without any 9 ...

ONLY SHORTDISTANCE 1. Pls check the polarity of the battery is correct. 1. Be sure you have already push the transmitting button( because first time for open the power and next will be for measure the distance) 1. Maybe the aim circle points are not correctly to the object. 2. Pls check the battery is powered. 2.Be sure the inner LCD got display 2. Maybe you have measured the front object when you measure a small object in far distance. 3. Pls push the power button more hardly to make it be connected. 3. Check if something blocks the object lens. 3. Make use two h ...

2. Round Symbol: for aim to the object 3. Distance: display the distance of the object 3 4 1 2 5 4. Measure unit: meter and yardage 5. Battery Hint： when the battery are in low power will occur NOTICE: When the rangefinder is operating in the SCAN mode it will continue to scan fro 60 seconds. Should you not require scanning to continue please stop the scan mode or turn the power off to conserve the battery power. 7 ...

ONLY SHORTDISTANCE 1. Pls check the polarity of the battery is correct. 1. Be sure you have already push the transmitting button( because first time for open the power and next will be for measure the distance) 1. Maybe the aim circle points are not correctly to the object. 2. Pls check the battery is powered. 2.Be sure the inner LCD got display 2. Maybe you have measured the front object when you measure a small object in far distance. 3. Pls push the power button more hardly to make it be connected. 3. Check if something blocks the object lens. 3. Make use two h ...