Black Horse Model RYAN BH 72 Instruction Manual Book

14 Vent tube Fuel pick- up tube Fuel fill tube  5) Test fit the stopper assembly into the tank. It may be necessary to remove some of the flashing around the tank opening using a modeling knife. If flashing is present, make sure none of it falls into the tank.  6) When satisfied with the alignment of the stopper assembly tighten the 3mm x 20mm machine screw until the rubber stopper ex- pands and seals the tank opening. Do not over tighten the assembly as this could cause the ...

4 Bottom side C/A glue Bottom side C/A glue Bottom side C/A glue  2) Using a modeling knife, remove the cov- ering at possition show below. Bottom side C/A glue Bottom side C/A glue Bottom side C/A glue Bottom side Bottom side Remove covering ...

16 Right side Left side Pushrod wire Pushrod wire  Install one adjustable metal connector through the third hole out from the center of one servo arm, enlarge the hole in the servo arm using a 2mm drill bit to accommodate the servo connector. Remove the excess mate- rial from the arm. After installing the adjustable metal con- nector apply a small drop of thin C/A to the bottom nut. This will prevent the con- nector from loosening during flight. INSTALLING THE THROTTLE PU ...

5  4) Drill 1,6mm pilot holes through the block of wood for each of the four mounting screws provided with the servo.  3) Using the thread as a guide and using masking tape, tape the servo lead to the end of the thread: carefully pull the thread out. When you have pulled the servo lead out, re- move the masking tape and the servo lead from the thread. † 5. Instal servo tray with aileron servo into the wing as same as picture below. thread Electric wire 2x10mm. Bottom side Secure Bottom side 2.INS ...

25 Top side C/A glue. C/A glue. Rudder Control horn.  Using a modeling knife cut away the cover- ing from the end of fuselage for the rudder hinge. Remove covering Nilon control clasp. M3 lock nut. 3 x 80mm. ...

7 II. FLAP. 1.INSTALLING THE FLAP SERVOS. Thread Electric wire. Flap 2.INSTALLING THE FLAP CONTROL HORN. R e m o v e covering 3mm x 40mm. Nilon control clasp. M3 lock nut. 2x10mm. C/A glue. ...

2 This instruction manual is designed to help you build a great flying aeroplane. Please read this manual thoroughly before starting assembly of your RYAN. Use the parts listing below to identify all parts. WARNING. Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is capable of causing injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU ASSUME ALL RISK & RESPONSIBILITY. If you are inexperienced with basic R/C flight we strongly reco ...

23 C/A glue. INSTALLING THE ELEVATOR CONTROL HORN. Control horn of Aileron Nilon control clasp. M3 lock nut. 3 x 40mm. C/A glue. Remove covering Bottom side ...