a/d/s/ IE6.1 / IE6.2 Owner's Manual

IE 6.1 IE 6.2 owner's manual front_cover.qxd 11/11/2002 8:37 AM Page 2

introduction 1 cautions 1 about this manual 1 keep listening, but be safe! 1 unpacking 2 placement 2 mounting instructions 2 warnings and tips 2 system configurations 3 speaker connections 4 maintenance 4 troubleshooting 4 audio adjustment 5 specifications 5 warranty information 6 introduction Thank you for purchasing an a/d/s/ bandpass subwoofer system. Please read the following instructions carefully. Following these instructions will ensure that your system will deliver the best possible performance. cautions To reduce risk of injury because of an accident or sudden stop, properly mount the subwoofer enclosure to the vehicle. about this manual These subwoofers can be used with factory or aftermarket loudspeakers to extend the bass response of the system by an octave or more. They are designed to be powered by an amplifier with a minimum of 25 watts of power. They are not intended to be powered by a head unit. The a/d/s/ IE6.1 / IE6.2 subwoofers are sophisticated tuned bandpass designs, that are computer optimized for maximum listening enjoyment and performance. The speakers in these a/d/s/ subwoofers feature oxygen-free copper wire voice coils wound on Kapton formers for maximum efficiency, fidelity and power handling. Butyl rubber surrounds allow long cone excursion while providing superior control of cone motion to ensure low distortion. The spider is made out of Comex and is extremely durable to meet the harsh demands of high performance car audio. keep listening, but be safe! Sustained listening to loud music over 100dB has been shown to cause permanent hearing damage. Systems using a/d/s/ components are capable of achieving volume levels which substantially exceed this level. When operating your system for sustained periods at high volume, be sure to use hearing protection to prevent long- term exposure. We want you to be able to enjoy the music for many more years. 1 ie_6.1_6.2.qxd 11/11/2002 8:43 AM Page 1

over, and lift it off the subwoofer. Remove the packing corners from the subwoofer and then remove it from the plastic bag. placement Unlike high frequency sound, our ears have difficulty locating the source of deep bass sounds. Consequently, you have a fair amount of flexibility in where you place the subwoofer in your vehicle. Typically the subwoofer is mounted in rear of the vehicle, either in the trunk, hatchback, or rear cargo area. For proper performance the port must not be closer than 3" from any walls, this will cause the performance to suffer. The enclosure can be mounted vertically or horizontally. mounting instructions Brackets are supplied for mounting the enclosure either vertically or horizontally. Remove the proper screws from the enclosure and replace the screws through the bracket and then into the enclosure. Repeat for the other side. Screw the enclosure into the floor of the vehicle being careful to note where brake and fuel lines run on the other side. Do not mount the enclosure directly against a hard surface without first putting down a piece of felt or cloth to prevent buzzes and rattles. Check to make sure that the enclosure screws are tightened properly, failure to do so may cause unwanted air leaks. Check to make sure that the screws mounting the enclosure to the floor are secure and tight. warnings and tips Always disconnect the battery ground wire before doing any work on your vehicle. Reconnect the cable only after the installation is complete and the wiring has been checked to make sure that there are no problems. If your radio features a code type security system, be sure you know the code before disconnecting the battery! 2 ie sub ie_6.1_6.2.qxd 11/11/2002 8:43 AM Page 2

installation consists of a factory stereo system driving an external amplifier powering the ie-series subwoofer. A more advanced system utilizes separate midrange and hi frequency speakers and multi- channel amplification, such as an a/d/s/ PH30.2 amplifier powering 346is speakers front and rear along with an ie series subwoofer. factory upgrade advanced system 3 factory headunit amplifier ie sub factory headunit amplifier ie sub ie_6.1_6.2.qxd 11/11/2002 8:43 AM Page 3

the positive (+) wire of the amplifier to the red terminal marked (+) of the speaker enclosure. Then connect the negative (-) wire from the amplifier to the black terminal marked (-) of the speaker enclosure. maintenance Normal maintenance of the subwoofer consists of keeping the unit clean and dust-free. Use a soft cloth or brush to remove dust without scratching or marring the finish. Do not use strong cleaners or solvents of any kind. Avoid spray cleaners or waxes, they can produce spotty glossy areas. troubleshooting No sound Check the speaker cables connected to the inputs of the subwoofer. Buzzes and rattles Locate the source of the noise and secure it. Place carpet,or felt under the subwoofer then securely mount it down. 4 amplifier ie sub + - + - ie_6.1_6.2.qxd 11/11/2002 8:43 AM Page 4

If the amplifier powering the ie subwoofer has an electronic crossover, adjust it for the best sound quality. Typical settings are between 50-100Hz. If the amplifier does not have a electronic crossover, use a 5mH coil in series between the positive (+) amplifiers wire and the red terminal (+) of the enclosure. 1. First turn factory radio to 3/4 volume. 2. Turn up/down gain to blend with mid and high speakers. 3. Adjust crossover of amplifier for best sound. 4. Repeat steps 2 and 3 until desired sound is achieved. specifications dimensions IE6.1 8”h x 12”w x 15 7/8”l IE6.2 9”h x 14.5”w x 23.75”l power handling IE6.1 100 watts RMS, 200 watts peak IE6.2 200 watts RMS, 400 watts peak 5 volume ie_6.1_6.2.qxd 11/11/2002 8:43 AM Page 5

Directed Electronics, Inc. promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of two years from the date of purchase by the dealer as indicated by the date code marking of the product PROVIDED the product was installed by an authorized Directed dealer. During this two year period, there will be no charge for this replacement PROVIDED the unit is returned to Directed, shipping pre-paid. If the unit is installed by anyone other than an authorized Directed dealer, the warranty period will be 1 year from date of purchase by the dealer as indicated by the date code marking of the product. During this 1 year period, there will be no charge for this replacement PROVIDED the unit is returned to Directed, shipping pre-paid. This warranty is non-transferable and does not apply to any unit that has been modified or used in a manner contrary to its intended purpose, and does not cover damage to the unit caused by installation or removal of the unit. This warranty is void if the product has been damaged by accident or unreasonable use, neglect, improper service or other causes not arising out of defects in materials or construction. ALL WARRANTIES INCLUDING BUT NOT LIMITED TO EXPRESS WARRANTY, IMPLIED WARRANTY, WARRANTY OF MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, AND WARRANTY OF NON-INFRINGEMENT OF INTELLECTUAL PROPERTY ARE EXPRESSLY EXCLUDED TO THE MAXIMUM EXTENT ALLOWED BY LAW, AND DIRECTED NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO ASSUME FOR IT ANY LIABILITY IN CONNECTION WITH THE SALE OF THE PRODUCT. DIRECTED HAS ABSOLUTELY NO LIABILITY FOR ANY AND ALL ACTS OF THIRD PARTIES INCLUDING ITS AUTHORIZED DEALERS OR INSTALLERS. Unit must be returned to Directed, postage pre-paid, with: consumer's name, telephone number, and address, authorized dealer's name and address, and product description. IN ORDER FOR THIS WARRANTY TO BE VALID, YOUR UNIT MUST BE SHIPPED WITH PROOF OF INSTALLATION BY AN AUTHORIZED DIRECTED DEALER. ALL UNITS RECEIVED BY DIRECTED FOR WARRANTY REPAIR WITHOUT PROOF OF DIRECTED DEALER INSTALLATION WILL BE COVERED BY THE LIMITED 1 YEAR PARTS AND LABOR WARRANTY. Note: This warranty does not cover labor costs for the removal and reinstallation of the unit. BY PURCHASING THIS PRODUCT, THE CONSUMER AGREES AND CONSENTS THAT ALL DISPUTES BETWEEN THE CONSUMER AND DIRECTED SHALL BE RESOLVED IN ACCORDANCE WITH CALIFORNIA LAWS IN SAN DIEGO COUNTY, CALIFORNIA. 6 ie_6.1_6.2.qxd 11/11/2002 8:43 AM Page 6

front_cover.qxd 11/11/2002 8:37 AM Page 1