Sub-Zero IC-27R Installation Manual

time without notice. Visit subzero.com/specs for the most up-to-date info ...

Product Information Important product information including the model and serial number of the unit are listed on the product rating plate. For column models, the rating plate is located inside the middle drawer near the drawer guide opposite the hinge. For tall and drawer models, the rating plate is located inside the cabinet, to the lef ...

SITE PREPARATION Opening Dimensions INTEGRATED MODELS 25" (635) OPENING DEPTH W OPENING WIDTH H OPENING HEIGHT SIDE VIEW TOP VIEW FRONT VIEW OPENING DIMENSIONS COLUMN W H IC-27R and IC-27FI 27" (686) 81" (2057) TALL W H 700TR, 700TFI, 700TCI 27" (686) 80" (2032) 736TR, 736TFI, 736TCI 36" (914) 80" (2032) DRAWERS W ...

SITE PREPARATION CAUTION The outlet must be checked by a qualified electrician to be sure that it is wired with the correct polarity. Verify that the outlet is properly grounded. WARNING Do not use an extension cord, two-prong adapter or remove the power cord ground prong. Electrical Installation must comply with all applicable electric ...

Plumbing Installation must comply with all applicable plumbing codes. For models with an ice maker, the water supply line should be located within the shaded area shown in the illustrations. The water supply line should be connected to the house supply with an easily accessible shut-off valve. Do not use self-pierc ...

SITE PREPARATION Preparation Uncrate the unit and inspect for damage. Remove the wood base and discard shipping bolts and brackets. Remove and recycle packing materials. Do not discard the kickplate, anti-tip bracket and hardware. Remove the kickplate by removing the screws holding it in place. IMPORTANT NOTE: For drawer models, the upper ...

SITE PREPARATION CONCRETE WEDGE ANCHOR INSTALLATION: 1 Drill a 3/8" (10) diameter hole any depth exceeding the minimum embedment. Clean the hole or drill additional depth to accommodate drill fines. 2 Assemble the washer and nut flush with the end of anchor to protect threads. Drive the anchor through the materia ...

INSTALLATION Placement CAUTION Before moving the unit into position, secure the door/ drawers closed and protect any finished flooring. Use an appliance dolly to move the unit near the opening. Front and rear leveling legs can be adjusted from the front once the unit is positioned. If the unit has been on its back or side, it must stand ...

INSTALLATION Water Line Purge the water line prior to final connection to the unit. This will remove any debris that may be present in the tubing from installing the new water line. Connect the plastic tubing from the unit to the house water supply line with the fitting connection kit provided. Check all water lin ...