Morso 1410 Instructions For Installation And Use Manual

E-Mail: [email protected] · Website: www.morsoe.com Morsø Jernstøberi A/S - 06.09.2006 - 72144600 ...

If smoke spillage occurs when the fire door is opened, it is probably due to poor chimney draft. This type of stove requires at least 12 pa of chimney draft to achieve satisfactory com- bustion and smoke spillage prevention. However, in cases where the stove door is opened too vigorously you could expect that slight smoke spillage may occur. The smoke gas temperature at the rated output is 294˚ C relative to 20˚ C. The smoke gas flow is 5.43 gr/sec. If you have any doubts, you may want to have your installer measure the draft in the chimney. Draft conditions The chimne ...

fire lighters or 7 - 10 rolled up sheets of newspaper, underneath roughly 1 kg of dry kindling. 2. Fully open the top vent so that the secondary air supply can enter the firebox. 3. After the paper/fire lighters have caught fire, leave the fire door ajar about 2-3 cm, so that the chimney draws well. The ash door on the 1400 series must remain closed during normal use and only opened when removing the ash pan. 4. After 5-10 minutes the chimney draft should be established, at this point close the fire door. If all the necess ...

are still glowing embers in the bed. Spread the em- bers across the bottom, but concentrated mostly to- wards the front of the stove. 6. Place three pieces of fuel weighing roughly 0.6 kg and measuring about 25 cm in length across the coals in one layer, with spacing of roughly 1 cm between the pieces of wood. 7. When the secondary air supply (top vent) is opened all the way and the door is closed, the new fuel will ignite in a few minutes. 8. Once the new fuel has taken, adjust the secondary air amount to the desired setting; optimal c ...

If smoke spillage occurs when the fire door is opened, it is probably due to poor chimney draft. This type of stove requires at least 12 pa of chimney draft to achieve satisfactory com- bustion and smoke spillage prevention. However, in cases where the stove door is opened too vigorously you could expect that slight smoke spillage may occur. The smoke gas temperature at the rated output is 294˚ C relative to 20˚ C. The smoke gas flow is 5.43 gr/sec. If you have any doubts, you may want to have your installer measure the draft in the chimney. Draft conditions The chimne ...

fire lighters or 7 - 10 rolled up sheets of newspaper, underneath roughly 1 kg of dry kindling. 2. Fully open the top vent so that the secondary air supply can enter the firebox. 3. After the paper/fire lighters have caught fire, leave the fire door ajar about 2-3 cm, so that the chimney draws well. The ash door on the 1400 series must remain closed during normal use and only opened when removing the ash pan. 4. After 5-10 minutes the chimney draft should be established, at this point close the fire door. If all the necess ...

E-Mail: [email protected] · Website: www.morsoe.com Morsø Jernstøberi A/S - 06.09.2006 - 72144600 ...

Morsø, the largest stove manufacturer in Denmark, has been making cast-iron stoves of the highest qual- ity since 1853. By carefully following the instructions below, we are certain that you will enjoy many years of comfortable warm from your new Morsø stove. CONTENTS 1.0 Installing your Morsø stove Page 1.1 Unpacking the stove 3 1.2 Installing the stove 3 1.3 Chimneysweep 3 1.4 Stove placement/distance requirements 3 1.5 The chimney 4 1.6 Pipe connections 5 1.7 Connecting to a masonry chimney 6 1.8 Connecting to a steel chimney 9 1.9 Draft conditions 7 2.0 F ...