Acnodes IPS Operation & User’s Manual

4.1.3.2 Remote Mouse Settings A common problem with KVM devices is the synchronization between the local and remote mouse cursors. The IP-KVM switch addresses this situation with an intelligent synchronization algorithm. There are two mouse modes available on the IP-KVM switch. Auto mouse speed The automatic mouse speed mode tries to detect the speed and acceleration settings of the host system automatically. See the section below for a more detailed explanation. Fixed mouse speed This mode just translates the mouse movements from the Remote Console in a way ...

3. Hardware installation 3.1 Operation Overview Figure 3-1 shows the connections of IP-KVM switch to its host, to peripheral devices, to the power source and to the local area network. Figure 3-1.a: IP-KVM switch usage scenario Figure 3-1.b: IP-KVM switch usage scenario IP-KVM switch redirects local keyboard, mouse, and video data to a remote administration console. All data is transmitted with the TCP/IP protocol family. IP-KVM switch can be used in a multi administrator and multi server environment as well. Attaching one or several IP-KVM switches to a KVM swit ...

Q 011: Every time I open a dialog box with some buttons the mouse pointers are not synchronous anymore A 011: Please check, if you have an option like ”‘Automatically move mouse pointer to the default button of dialog boxes”’ enabled in the mouse settings of the operating system. This option needs to be disabled. 8. Certificates FCC This equipment has been tested and found to comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interf ...

Challenge Password Some certification authorities require a challenge password to authorize later changes on the certificate (e.g. revocation of the certificate). The minimal length of this password is 4 characters. Confirm Challenge Password Confirmation of the Challenge Password Email The email address of a contact person that is responsible for the IP-KVM switch and its security. Key length This is the length of the generated key in bits. 1024 Bits are supposed to be sufficient for most cases. Longer keys may result in slower response time of the IP-KVM sw ...

Step 2 Connect the monitor to the IP-KVM switch console side. Step 3 Connect the keyboard to the IP-KVM switch console side. Step 4 Connect the mouse to the IP-KVM switch console side. Step 5 Connect a VGA cable (15-pin HDDB Male / Male) with the Male side to both of the PC and the host of the IP-KVM switch. Step 6 Connect one end to the PS/2 mouse port on the computer, and the other end to the host PS/2 mouse port on the IP-KVM switch. Step 7 Connect one end to PS/2 keyboard port on the computer, and the other end to the host PS/2 keyboard port on the IP-KVM swi ...

Q 011: Every time I open a dialog box with some buttons the mouse pointers are not synchronous anymore A 011: Please check, if you have an option like ”‘Automatically move mouse pointer to the default button of dialog boxes”’ enabled in the mouse settings of the operating system. This option needs to be disabled. 8. Certificates FCC This equipment has been tested and found to comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interf ...

value in brackets describes the connection to the Remote Console. “Norm” means a standard connection without encryption, “SSL” indicates means a secure connection. Figure 5-15. Status line Furthermore, both the incoming (“In:”) and the outgoing (“Out:”) network traffic are visible (in kb/s). If compressed encoding is enabled, a value in brackets displays the compressed transfer rate. Figure 5-16. Status line transfer rate For more information about Monitor Only and Exclusive Access settings, see the according sections ...