Servend MDH-402 Series Installation, Use & Care Manual

4-5 2. Remove the merchandiser. The merchandiser is removed by taking out the two (2) screws located at the top of the merchandiser. Once the screws are removed, lift and rotate the top of the merchandiser towards you and then remove the merchandiser from the unit. NOTE: When the merchandiser is removed, an electrical safety switch kills power to the entire unit. 3. Remove rocking chute door. 4. Remove the decorative ice chute by pulling the cotter pin out on the right side of the chute rod and pulling the chute rod toward the left side of the d ...

4-7 4. Rinse all of the parts with clean water. 5. Prepare 2 gallons of sanitizing solution by mixing a 1/2 ounce of household bleach (that contains 5.25% sodium hypochlorite) with 2 gallons of 120°F (49°C) water. The mixture should not exceed 100 PPM of chlorine. Or mix a solution of any approved sanitizer, following the directions for mixing and applying the sanitizer. 6. Apply sanitizer to all parts with clean cloth, or by spraying. 7. Allow to air dry. DO NOT RINSE. 8. Reassemble the ice crusher assembly by following the instructions in th ...

Part Number 020003999 6/14 5-5 Liquid Level Control Troubleshooting END START Remove red and black wires from LLC. Is pump motor operation intermittent ? Does pump motor come on? Black and/or red probe shorted. Remove probes, straighten or replace if necessary. Short “H” and “C” terminals on LLC. Does the pump motor shut off? Measure AC voltage across load terminals on LLC. Check pump motor and wiring. Check probe harness, harness connections and water supply. Is line voltage (± 10%) present ? Replace LLC Yes No Yes Yes Yes Yes No No No No END STA ...

ADA Key Pad Matrix Finish Installation 11. Put the splash panel and merchandiser back onto the unit and reinstall the screws that hold them in place. NOTE: Restore power to the unit. STARTING YOUR BEVERAGE SYSTEM & DISPENSER Upon completion of the beverage dispenser and/or system installation, all tubing, dispenser and system components must be cleaned and sanitized prior to use. NOTE: At installation, equipment, dispensers and tubing get moved through many environments, dirt, dust, chases, insulation, drywall, etc. It is an i ...

4-7 4. Rinse all of the parts with clean water. 5. Prepare 2 gallons of sanitizing solution by mixing a 1/2 ounce of household bleach (that contains 5.25% sodium hypochlorite) with 2 gallons of 120°F (49°C) water. The mixture should not exceed 100 PPM of chlorine. Or mix a solution of any approved sanitizer, following the directions for mixing and applying the sanitizer. 6. Apply sanitizer to all parts with clean cloth, or by spraying. 7. Allow to air dry. DO NOT RINSE. 8. Reassemble the ice crusher assembly by following the instructions in th ...

2-15 ADA KEY PADS These instructions are for installations with this option. 1. Remove power from the unit. Merchandiser Removal 2. Remove the medallion from merchandiser to gain access to the area above the valve mount cap. Medallions are removed through the top of standard merchandisers and either side of the extended merchandisers. Splash Panel Removal 3. Remove the splash panel from the unit by removing the two (2) Phillips head screws holding it in place. ADA Wiring NOTE: Follow these instructions for the right and left sides ...

1-1 Section 1 General Information Read This Manual Manitowoc Beverage Equipment (MBE) developed this manual as a reference guide for the owner/operator and installer of this equipment. Please read this manual before installation or operation of the machine. A qualified service technician must perform installation and start-up of this equipment. Consult Section 5 within this manual for service assistance. If you cannot correct the service problem, call your MBE Service Agent or Distributor. Always have your model and serial number available when you call. Your Service ...