Sharp MX-4110N Installation Manual

G. Check of the connected position of main unit and finisher 1) Insert the rail of the finisher into the slit on the rail reception sheet metal of the main unit, install the finisher. 2) Remove the screw, and remove the connector cover on rear side of the finisher. 3) Check that the center of the screw hole of the finisher is in the range of specification of an oval hole of the connection fixture that exist on main body rear side. * When not the range of specification, execute the following adjustment. If the adjustment is not required, Prog ...

MX-5111N Service Manual Transit, Installation (using) environment, Note 1. Installing (use) conditions Before installing the machine, check that the following installing (use) conditions are satisfied. If the installing (use) conditions are not satisfied, the machine may not display full performances, resulting in troubles. It may also cause safety problems. Therefore, be sure to arrange the installing (use) conditions before setting up the machine. A. Transportation space For installation of a large size machine, be sure to chec ...

4) Remove the reverse tray. 5) Remove the screws, and remove the interface left cabinet. 6) Remove the screws, and remove the paper pass latch recep- tion parts and the positioning pin. D. Attaching the mylar 1) Attach the mylar (Packed items) to the position indicated in the figure. E. Attach the interface left cabinet 1) Insert the rib of the interface left cabinet into the slit on the lower surface of the scanner left cabinet. Install the interface left cabinet with the screw. F. Installation of the connection fixture F/R 1) Install the connection fixt ...

C. Attach the operation panel upper cover D. Connect the connector of the IC card reader to the connector of the machine E. Turn ON the power of the main unit 1) Connect the power plug of the machine to the power outlet, and turn ON the main power switch and the operation panel power switch. F. System setting modification IC card reader device registration 1) Device registration a) Enter the card reader setting menu as shown below. System SettingsUser ControlCard Reader Device Registration b) Press [Read] button. c) Disconnect the connector which links ...

MX-5111N Service Manual Transit, Installation (using) environment, Note 1. Installing (use) conditions Before installing the machine, check that the following installing (use) conditions are satisfied. If the installing (use) conditions are not satisfied, the machine may not display full performances, resulting in troubles. It may also cause safety problems. Therefore, be sure to arrange the installing (use) conditions before setting up the machine. A. Transportation space For installation of a large size machine, be sure to chec ...

D. Turn on the power of the main unit 1) Connect the connector. 2) Connect the power plug of the machine to the power outlet, and turn ON the main power switch and the operation panel power switch. ...

a. Side plate size switch 1) Remove four fixing screws (blue screws) which are fixing the upper and the lower sections of the side plate F and the side plate R. 2) Adjust the mark position of the tray and the side plates in the lower section of the side plates F/R according to the desired size. Also adjust the upper section according to the desired size, and fix with the four fixing screws (blue screws). b. Auxiliary guide size switch 1) When switching the size of the side plate R, check to confirm the mark position ( ) of the side plate R and t ...