Intellinet 524681 Quick Installation Manual
Text of the manual
Thank you for purchasing the INTELLINET NETWORK SOLUTIONS™
Wireless 300N 3G Router, Model 524681.
This quick install guide presents the basic steps required for setting up
and operating this device. For detailed instructions and specifications,
refer to the user manual on the CD enclosed with this product at
www.intellinet-network.com.
System Requirements
• For a complete list of compatible 3G USB modems, visit
www.intellinet-network.com
Package Contents
• Wireless 300N 3G Router
• Power adapter
• Ethernet Cat5 RJ45 cable: 1.0 m (3 ft.)
• USB extension cable: 1.0 m (3 ft.)
• User manual on CD; quick install guide
NOTE: Some screen images have been modified to fit the format of this
guide. Screen images on all compatible operating systems are similar.
1. With the router properly positioned on a flat, stable surface, connect .
your 3G / 3.5G USB modem by inserting it in the USB port on the
right side of the router’s front panel (below).
2. Connect all your computers, network devices (such as game consoles
or switches/hubs) to the LAN port(s) of the router (back panel, below).
3. Plug the power adapter into an AC electrical outlet, then connect it to
the 12VDC jack on the router. The Power LED on the front panel
should be on, and the other LEDs should light if the devices they
correspond to are also powered on and properly connected to the
router. (If they don’t, check the connections.)
Wireless 300N 3G Router
4
3 2 1 WAN
ON/OFF
Reset/WPS
12VDC
The following procedure is for configuring the Wireless 300N 3G Router
using your Web browser. NOTE: For the initial configuration, a computer
with a wired Ethernet connection is required.
1. Set your computer to obtain an IP address from the wireless router:
Go to Start (in the lower-left corner of your desktop), then go to
Control Panel. Double-click Network Connections, then double-click
Local Area Connection. When the Local Area Connection Status
screen displays, click “Properties.”
2. When the Local Area Connection Properties screen displays, select
“Internet Protocol (TCP/IP),” then click “Properties.”
5
