Prodigy Preferred Owner's Manual

www.prodigymeter.com Prodigy Meter Owner’s Manual 20 STEP 4 : Check if the Test Result is in Range. After seven (7) seconds, the control solution test result appears on the display. Compare the test result with the range printed on the test strip vial. The result should fall within the printed range. See Figure 19. Out of Range Results If test results fall outside the range printed on the test strip vial, check “Trouble-Shooting Guide” located in the “System Troubleshooting” Section and repeat the test. If you continue to get out-of-range re ...

www.prodigymeter.com Prodigy Meter Owner’s Manual 18 Performing a Control Solution Test Start with the meter off. STEP 1: Insert Test Strip Insert a test strip with the contact bar end entering into the test slot first. Push the test strip as far as it will go without bending it. The meter turns on automatically and beeps. See Figure 14. STEP 2: Mark as a Control Solution Test After the “ ” symbol appears on display, press and hold the “M” button and a “ ” symbol appears on the display. With the “ ” symbol on the display, the m ...

www.prodigymeter.com Prodigy Meter Owner’s Manual 2 Read this before using your Prodigy Preferred TM Meter. The following basic safety precautions should always be taken. • Close supervision is necessary when the device is used by, on, or near children, handicapped persons or invalids. • Use the device only for the intended use described in this manual. • Do not use test strips and control solutions that are not supplied by the manufacturer. • Do not use the device if it is not working properly, or if it has suffered ...

1.800.243.2636 Prodigy Meter Owner’s Manual STEP 8: Unit of Measurement Press and release the “M” button until the unit of measurement you are choosing appears on the display. See Figure 11. Your meter can display test results in milligrams per deciliter (mg/dL) or millimoles per liter (mmol/L). • The mg/dL unit is standard in the United States. • The mmol/L unit is standard in Canada. STEP 9: Delete Memory Press the “SET” button and “dEL” will appear with the flashing “ ” symbol. When the “dEL” symbol and the flashi ...