TRENDnet TPE-S44 - Switch Quick Installation Manual
Text of the manual
8-Port 10/100Mbps PoE Switch
TPE-S44
1.11
ŸQuick Installation Guide (1)
ŸTechnical Specifications (4)
ŸTroubleshooting (5)
If any of the above contents are missing, please contact your reseller.
1. Before You Start
ŸComputer with network adapter installed
ŸCat. 5, Cat. 5e or Cat. 6 RJ-45 network cable
The surface must support at least 430g for the Switch
ŸThe power outlet should be within 1.82m (6ft) of the Switch
Visually inspect the
Device is off.
LAN port connected at 10/20 Mbps or
100/200Mbps (Half/Full Duplex).
LAN port data transmitting/receiving
10/20Mbps or 100/200Mbps
(Half/Full Duplex).
When the Switch i
3. Hardware Installation
Note: The maximum amount of power available is 15.4 Watts per port and 30
Watts total. If a power overload has occurred, the Switch will prioritize the
distribution of power by port (from lowest to highest). That is, port 1 will receive
the highest priority and port 4 will receive the lowest priority. The ports with
lower priority wi
ŸIEEE 802.3 10Base-T
ŸIEEE 802.3u 100Base-TX
ŸIEEE 802.3af Power over Ethernet
Network Media
Ÿ10Mbps: Cat 3,4,5 Unshielded Cable
Ÿ100Mbps Cat 5,5e,6 Unshielded Cable
Data Transfer Rate
ŸEthernet: 10/20Mbps (half/full-duplex)
ŸFast Ethernet: 100/200Mbps (half/full-duplex)
Power
48V DC 800mA External Power Adapter
Hard
