Draper MS560/3 Instructions

I PART No.MS560/3 •INSTRUCTIONS• 06/99 IMPORTANT: PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE USE. UNDERSTANDING HOW THIS MACHINE WORKS AND SETTING IT CORRECTLY IS FUNDAMENTAL TO OBTAINING A SATISFACTORY RESULT. MITRE SAW

COMPONENT PARTS 1. Saw table. 2. Two plastic feet with screw holes for bench mounting. 3. Saw frame assembly. 4. Two cut depth stops. 5. Guide rods. 6. Washer for pivot arm (see STEP 1). 7. Pivot arm. 8. Angle indicator. 9. Four grub screws. 10. Hexagon key. 11. Rubber feet. 12. Material vice clamp. 13. Adjustable length stops. �✖✌ �✗✌ �✙✌ �✘✌ �✕✖✌ �✕✔✌ Specification: Max. cutting width clamped at 45º.............100mm Max. cutting width clamped at 90º.............160mm Max. cutting width unclamped at 90º.........110mm Max. cutting height.....................................110mm Blade lengths.............................................560mm Blade widths 18, 24 TPI...............................40mm Bow saw ...............................20mm Table size ..................................76x348mm (WxL) Max. reach of adjustable length stop....385mm �✕✌ �✕✕✌ �✢✌ �✕✗✌ �✛✌ �✚✌ �✜✌

ASSEMBLY OF ACCESSORIES The material vice clamp �✕✖✌ can be mounted on the left or right hand side of the saw table front for holding workpieces securely. The adjustable length stop �✕✗✌ can be mounted at either end of the saw table and set for the required length of cut. Replacement blades are available from your local Draper stockist; 18TPI - Stock No.57810, 24TPI - Stock No.57811, Bow Saw Blade - Stock No.57812. STEP 1. STEP 2. STEP 3. STEP 4. STEP 5. STEP 6. Turn 5-1/8 turns �✚✌ When fitting blade, always ensure teeth point forwards.

following points are correct: (a) The saw blade is tensioned sufficiently to avoid ‘whip’ which will cause the blade to deviate from a true cut. (b) The blade is ‘in line’ and central to the frame. (c) Blade tension is always released after use. (d) The workpiece is square and true to the base casting. (e) The correct type of blade is used. SAFETY FIRST TO AVOID INJURY: Do not remove the blade guard whilst fitting the bow saw blade to the frame. Refit the blade guard when work is complete and when removing the blade from the frame. After assembly has been carefully carried out, always test your mitre saw and the angles with some scrap timber, to ensure the machine is assembled correctly and cutting true. DRAPER TOOLS LIMITED, Hursley Road, Chandler's Ford, Eastleigh, Hants. SO53 1YF. England. Tel: (01703) 266355. Fax: (01703) 260784. ©Published by Draper Tools Ltd. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, mechanical photocopying, recording or otherwise without prior permission in writing from Draper Tools Ltd. SAW SETTING IMPORTANT WARNING