Honeywell Lyric T6 Pro Wi-Fi Professional Install Manual

Setup using the thermostat • After the Lyric thermostat has powered up, touch START SETUP on the thermostat. You’ll be asked if you want to perform setup via Lyric app. Touch No. • Touch or to toggle between Installer Set Up (ISU) options. • Touch Edit or touch text area, and then touch or to edit default setup option. • Touch Done or touch text area to confirm the setting or press Cancel. • Touch or to continue to setup another ISU option. NOTES: • To see a list of all setup parameters, go to "Installer setup options (ISU) – adv ...

R Power Rc [R+Rc joined by Slider Tab] Y Compressor contactor C 24VAC common W Heat relay G Fan relay NOTES: 1 Available wiring configurations differ by product models/product numbers. 2 Use 18- to 22- gauge thermostat wire. Shielded cable is not required. 3 Set the R Slider Tab on the UWP to the up position (1 wire) for 1 transformer systems or the down position (2 wires) for 2 transformer systems. See "Setting Slider Tabs" on page 4. 4 Set the U Slider Tab to the up position (1 wire) for non-powered ventilation or the down position (2 wires) for pow ...

Honeywell International Inc. 1985 Douglas Drive North Golden Valley, MN 55422 http://customer.honeywell.com ® U.S. Registered Trademark. © 2016 Honeywell International Inc. 33-00153—07 M.S. Rev. 08-16 Printed in U.S.A. CAUTION: MERCURY NOTICE If this product is replacing a control that contains mercury in a sealed tube, do not place the old control in the trash. Contact your local waste management authority for instructions regarding recycling and proper disposal. CAUTION: EQUIPMENT DAMAGE HAZARD Compressor protection is bypassed during testing. To preven ...

# ISU ISU Name ISU Options (defaults in bold) Notes 1000 Vent Type None, ERV/HRV, Passive, Fresh Air Damper None: The thermostat does not control ventilation. ERV/HRV: The thermostat controls an Energy Recovery Ventilator or Heat Recovery Ventilator for ventila­ tion. Passive (Fan Only): The thermostat turns on the fan for ventilation. When set to passive fan, the thermo­ stat does not control a damper or ventilator. The passive ventilation/passive fan setting only runs the indoor blower fan. This setting does not open a damper or run a venti ...

Number Alert/Reminder Definition 181 Replace Air Filter (1) Replace air filter (1). Reset the timer by touching the "dismiss" button on thermostat screen after it is replaced. 182 Replace Air Filter (2) Replace air filter (2). Reset the timer by touching the "dismiss" button on thermostat screen after it is replaced. 183 Clean Humidifier Tank and Replace Water Filter Clean humidifier tank and replace the water filter, or contact dealer to do this for you. Reset the timer by touching the “dismiss” button on the thermostat screen after it is replaced. 184 Replace Humi ...

1H/1C Heat Pump System R Power Rc [R+Rc joined by Slider Tab] Y Compressor contactor C 24VAC common O/B Changeover valve G Fan relay 2H/1C Heat Pump System R Power Rc [R+Rc joined by Slider Tab] Y Compressor contactor C 24VAC common O/B Changeover valve G Fan relay Aux Auxiliary heat E Emergency heat relay L Heat pump fault input 2H/2C Heat Pump System R Power Rc [R+Rc joined by Slider Tab] Y Compressor contactor (stage 1) C 24VAC common O/B Changeover valve G Fan relay Y2 Compressor contactor (stage 2) L Heat pump fault input 3H/2C Heat Pump System R Power Rc [R+Rc jo ...