Krill Avanti S jet 2.1m ARF Assembly Manual

(Make sure you have selected the correct pipe for your engine size) As shown below there are two types of pipes for the JetCat p100RX and the p140RX.If you are not using JetCat Turbines then you just need to look at the thrust (N) which corresponds to your engine and the JetCat turbines. p100RX =100N of thrust p140RX=140N of thrust Installing the pipe Test fit the pipe in your Avanti. It should ...

Radio equipment: • Digital servo:5 JR ds8411 (ailerons, elevators, nose steering 3 JR ds8911 (flaps and rudder) (2 JR ds 8915(vectoring thrust-optional) • For pneumatic landing gear operation: one dual air valve (not included) • For pneumatic brake operation :one single air valve(not included) • Powerbox systems range from: Sports setup: powerbox champion or powerbox royal. 3d setup: powerbox royal or powerbox cockpit + igyro • We recommend using a powerbox smoke pump • RX Batteries can be from 2500-3500mah ...

Radio equipment: • Digital servo:5 JR ds8411 (ailerons, elevators, nose steering 3 JR ds8911 (flaps and rudder) (2 JR ds 8915(vectoring thrust-optional) • For pneumatic landing gear operation: one dual air valve (not included) • For pneumatic brake operation :one single air valve(not included) • Powerbox systems range from: Sports setup: powerbox champion or powerbox royal. 3d setup: powerbox royal or powerbox cockpit + igyro • We recommend using a powerbox smoke pump • RX Batteries can be from 2500-3500mah ...

rudder vector servo install. there is not a hole for the servo to go so one needs to be cut. The ideal place is to cut a hole on the turbine mounting formers on the left hand side looking from the back of the plane. After checking the servo arm will move along the fuselage skin and that the servo is aganst the cross former as seen in the picture. Use a sharp knife at cut out the hole.when checked you can now double up the mount with plywood to take 4 servo screws.(it is not recommended to you grommets as this two servos need to be a solid as ...

Smoke tank and smoke pump. When using a single fuel cell where does the smoke pump go? There is plenty of room to fit a 40oz (1200cc) tank under the main fuel cell. You can even fit a 52oz tank in there as well. Fixed in place with 2 rails either side and Velcro straps. Smoke pump is best mounted under the board on the front tank former. This is best as the tubing and wires are all in the right area for plumbing. Smoke pump Smoke vent next to the fuel vents. 18. ...