mr. steam CU-360 Installation, Operation & Maintenance Manual

_________________________________________________________________ 26 Water Gauge & Gauge Glass Installation IMPORTANT: Only properly trained personnel should install and maintain water gauge glass and connections. Pressure in genera- tor must be at zero before proceeding. Remember to wear safety gloves and glasses during installation. Before installing, make sure all parts are free of chips and debris. 1. Apply Teflon tape or pipe dope to pipe threads. Install top gauge fitting (fitting without a drain valve) into the uppermost ...

Panel Interior mr.steam® CU Series Installation, Operating & Maintenance Manual _________________________________________________________________ 18 Automatic Blowdown System Kit Installation CU-81600 Motorized Drain Valve Assembly Hazard of Electric Shock. Disconnect all power supplies before making wiring connections. Note: Reference applicable wiring diagram. 1. Remove blank cover and mount the Automatic Blowdown Control Panel on the front of the generator cabinet with screws and nuts provided. 2. Remove t ...

(see page 16, Diagram B). Hazard of Electric Shock. Disconnect all power supplies before making wiring connections. 7. Connect wiring to CU steambath generator. See applicable wiring diagram. Remove jumper next to 120v control supply input of CU generator. Using AWG #14 or larger wire, connect terminals R and B of controller to the terminals vacated by the jumper. Also connect ground wire from controller ground terminal to CU ground terminal. NOTE: All factory ground wiring is color coded using green/yellow insulation: 8. S ...

_________________________________________________________________ 24 Maintenance Instructions To establish a good preventive maintenance program, we suggest that the site equipment foreman, engineer or owner/operator familiarize themselves with these guidelines: 1. Daily blowdown at max 5 PSIG operating pressure is recommended for best steambath generator performance. In order to safeguard the heating element(s) within the steambath generator, the main wall switch and the steambath generator switch shall both be placed in the OF ...

_________________________________________________________________ 14 100F 102 104 106 108 110 112 114 116 118 120 F1 Plus Control (Front) F1 Plus Sensor CU-HL Hi Limit Control Acrylic Shield F1 Plus Control 3⁄4" Steam Solenoid Valve F1 Plus Sensor Cover 3⁄4" Steam Head (Back) CU-HL Sensor Cover F1 Plus® Kit Contents Mr.Steam CU Steambath Generator can be used for one or two steam rooms in accordance with Page 5, Item D. Each room requires one F1 Plus Kit sized for the room. See page 3 (figure 1) for typical installation. F ...

(see page 16, Diagram B). Hazard of Electric Shock. Disconnect all power supplies before making wiring connections. 7. Connect wiring to CU steambath generator. See applicable wiring diagram. Remove jumper next to 120v control supply input of CU generator. Using AWG #14 or larger wire, connect terminals R and B of controller to the terminals vacated by the jumper. Also connect ground wire from controller ground terminal to CU ground terminal. NOTE: All factory ground wiring is color coded using green/yellow insulation: 8. S ...

Control Circuit Wiring Diagram Models CU-2000 and higher with F1 Plus Temperature Control System and Optional Automatic Blowdown Assembly IMPORTANT: 1. F1 Plus sensors are intended to be field installed within the steam room at the location selected by the designer/architect. DO NOT LOCATE THE F1 PLUS SENSORS NEAR OR ABOVE THE STEAMHEAD(S) AS THIS MAY CAUSE DIRECT STEAM EMISSION TO INTERFERE WITH STEAMROOM TEMPERATURE REGULATION. 2. Autoflush System 24 hr. timer and F1 Plus operating settings are at the discretion of the owne ...