Sony XR-CA330 Installation/Connection Service Manual

•Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperatures, such as in direct sunlight or near heater ducts. •Use only the supplied mounting hardware for a safe and secure installation. Mounting angle adjustment Adjust the mounting angle to less than 20°. How to detach and attach the front panel Before installing the unit, detach the front panel. A To detach Before detaching the front panel, ...

82 5% 1/8W R912 1-216-174-00 RES-CHIP 100 5% 1/8W R913 1-216-174-00 RES-CHIP 100 5% 1/8W R914 1-216-178-00 RES-CHIP 150 5% 1/8W R915 1-216-178-00 RES-CHIP 150 5% 1/8W R916 1-216-178-00 RES-CHIP 150 5% 1/8W R919 1-216-176-11 RES-CHIP 120 5% 1/8W R920 1-216-174-00 RES-CHIP 100 5% 1/8W R921 1-216-172-00 META ...

Setting: [SOURCE] button: FM [FREQUENCY SELECT] switch:FM 50 k (XR-CA340 only) Procedure: L-CH Stereo separation: A-B R-CH Stereo separation: C-D The separations of both channels should be equal. Specified Value: Separation more than 30 dB Adjustment Location: See page 17. FM RF signal generator Carrier frequency : 97.9 MHz (XR-CA330) 98.00 MHz (XR-CA340) Output level : 70 dB (3.2 mV) Mode : stereo Modulation : main: 1 kHz, 20 kHz deviation (26.7%) sub: 1 kHz, 20 kHz deviation (26.7%) : 19 kHz pilot: 7.5 kHz deviation (10%) 0.01 µF set ant ...

•Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperatures, such as in direct sunlight or near heater ducts. •Use only the supplied mounting hardware for a safe and secure installation. Mounting angle adjustment Adjust the mounting angle to less than 20°. How to detach and attach the front panel Before installing the unit, detach the front panel. A To detach Before detaching the front panel, ...

• MAIN BOARD IC1 MN101C49GTH (SYSTEM CONTROLLER) Pin No. Pin Name I/O Description 1 VREF – — Reference voltage (0V) terminal (for A/D converter) 2 VSM I FM and AM signal meter voltage detection input from the FM/AM tuner unit (A/D input) 3 to 6 NC — Not used 7 NOISE-DET I Not used 8 MPTH I Not used 9 NC — Not used 10 VREF + — Reference voltage (+5V) terminal (for A/D converter) 11 VDD — Power supply terminal (+5V) 12 OSC2 O Main system clock output terminal (18.432MHz) 13 OSC1 I Main system clock input terminal (18.432MHz) 1 ...

(more than 60 g) Reverse CQ-403R (more than 2.12 oz) • Tape Tension Measurement 1. Clean the following parts with a denatured-alcohol-moistened swab: playback head pinch roller rubber belt capstan idler 2. Demagnetize the playback head with a head demagnetizer. 3. Do not use a magnetized screwdriver for the adjustments. 4. The adjustments should be performed with the power supply voltage (14.4 V) unless otherwise noted. Note: With this ...