Rocom SMT-i6020 Operation & User’s Manual

Call Move You can move a call back and forth between the IP phone and mobile phone. When IP phone is connected with smart phone’s bluetooth headset, a call can be transferred from IP phone to smart phone using system function and bluetooth function. 1 Go to [Menu]  [Settings]  [Bluetooth & Headset]  After setting the [Bluetooth Mode] to the smartphone, connect your smartphone to the IP phone. - For more information about how to setup, refer to the ‘Bluetooth & Headset’ part of this manual. 2 During communication using the IP phone, if y ...

SAFETY CONCERNS The purpose of the Safety Concerns section is to ensure the safety of users and prevent property damage. Please read this document carefully for proper use. Conventions Warning Provides information or instructions that you should follow in order to avoid personal injury or fatality. Caution Provides information or instructions that you should follow in order to avoid a service failure or damage to your phone. Note Indicates additional information for referrence. Checks Provides the operator with checkpoints for ...

Call Waiting When there is an incoming call while the subscriber is already engaged, the subscriber is notified that a call is waiting so that the subscriber can park or end the previous call and pickup the new call. If the call waiting feature is enabled for a phone, the phone can accommodate as many calls as the call buttons configured. If no call button is configured, all incoming calls while the phone is engaged are treated as busy. You can enable/disable the call waiting function as follows: - Enable: Dial ‘Call Waiting-Enable’ function code. ...

Assembling the Cradle for Desk The installation angle of a phone can be changed depending on the assembly direction of the cradle. 1 Fix one latch of the cradle to the top or bottom groove of the phone. 2 Push the remaining latch into the remaining groove on the opposite side. 3 Place the phone on the installation location and check whether it shakes. ...