Teleste UHC-P Operation & User’s Manual

Introduction • 3 The power supply has an electrical screening of class 1 and it is intended for an indoor installation in a dry place. The unit must not be installed in a place where it can be exposed to dripping or splashing water. The operating voltage is 220…240 VAC, 50…60 Hz. ...

Installation • 4 Installation Quick Instructions • The DVP power supply unit is installed on the extreme left- hand side of the DVX002 installation frames (positions 1&2), but it can also be installed to any other frame position, if necessary. When the EASITM system consists of several installation frames, each frame must have a bus address specified (refer to the DVX002’s User Manual). • Lock the unit into place, connect the mains power cable to a 220…240 VAC, 50…60 Hz wall outlet and see that the green “MODULE” -indicator of the unit is li ...

Configuring the DVP432 • 10 Configuring the units using CATVisor Commander By clicking a device, the Configuration Display will show its configuration display pages. Each element has its own type of configuration display pages, which include all controls and settings that can be configured or monitored. The Configuration Display consists of several pages; Status, Input, …etc. Only one page is completely visible at one time. Other pages are visible as tabs. You can activate a page simply by clicking the tab's heading. The Configuration Display example. T ...

Introduction • 3 The power supply has an electrical screening of class 1 and it is intended for an indoor installation in a dry place. The unit must not be installed in a place where it can be exposed to dripping or splashing water. The operating voltage is 220…240 VAC, 50…60 Hz. ...

Configuring the DVP432 • 10 Configuring the units using CATVisor Commander By clicking a device, the Configuration Display will show its configuration display pages. Each element has its own type of configuration display pages, which include all controls and settings that can be configured or monitored. The Configuration Display consists of several pages; Status, Input, …etc. Only one page is completely visible at one time. Other pages are visible as tabs. You can activate a page simply by clicking the tab's heading. The Configuration Display example. T ...

Configuring the DVP432 • 10 Configuring the units using CATVisor Commander By clicking a device, the Configuration Display will show its configuration display pages. Each element has its own type of configuration display pages, which include all controls and settings that can be configured or monitored. The Configuration Display consists of several pages; Status, Input, …etc. Only one page is completely visible at one time. Other pages are visible as tabs. You can activate a page simply by clicking the tab's heading. The Configuration Display example. T ...