Sartorius M3P Installation And Operating Instructions Manual

Remove the rubber band from the doors of the weighing cham- ber. Place the interior draft shield (3) in the weighing chamber. Use forceps to position the pan support (2) on the draft shield, and place the weighing pan (1) on the pan support. Preparing the M3P-OOOV001 Filter Microbalance for Opera- tion For weighing filters with diameters ranging up to 70 mm (~ 2.8 in.): — Slightly lift the cover of the weighing chamber and turn it to the left or to the right — Place the spacer (16) and the interior draft shield (3) in the weighing chamber — Use f ...

indicate 0.000 mg, press the tare control to zero the display. Weighing with a Tare Container* The balance has built-in motorized Substitution weights (tare weights) for application of about 750 mg or 1,500 mg (accuracy approx. 1 mg) to expand the weighing range. lf the weight display indicates an "H," the tare Container ex- ceeds the capacity of the 1,500 mg electronic weighing range. Press the key labeled (10). The LED next to the symbol " ~ 750 mg" indicates that the 750 mg Substitution weight has been applied by m ...

General Directions for Working with the Balance Before you start weighing, please observe the following: After plugging your balance into a wall outlet using the power supply, make sure to allow for at least 2 hours' warmup. Working with a microbalance requires a steady hand and a smooth, uninterrupted technique. Use forceps or other suitable Utensils to place your sample on the pan. Do a few trial weighing procedures before you begin with actual weighing of your sample, because a weighing chamber that has not been opened for a relatively long period may have a te ...

range (both LEDs next to the Symbols " ~ 750 mg" and " ~ 1500 mg" go out). As soon as you obtain a zero readout, press the tare control (12) for at least 3 seconds until the calibration weight readout appears in the weight display (14). Center the calibration weight of the desired accuracy class on the weighing pan and dose the weighing chamber. A circle is now displayed above the "mg" symbol. An acoustic signal indicates the end of the calibration procedure. Open the weighing chamber and remove the calibratio ...

Scales" enclosed. Interfacing Devices with the Balance (RS Interface) Make sure that the interface port is electrically connected to the protective grounding conductor of the balance housing. The ca- bling supplied as accessory components is shielded and electri- cally connected on both ends to the cases of the connectors. This electrical connection may result in interference caused by cables scraping the floor or by transient currents if you have grounded the housing or connected the protective grounding conductor for line ...