Toro 22305 Operator's Manual

once again up to the upper line on the battery case (Fig. 4) and install the covers. 10. Install the battery into the chassis (Fig. 3). 11. Secure the battery with the bar and wing nuts removed previously (Fig. 3). 12. Using the bolt and wing nut supplied with the battery, connect the positive (red) cable to the positive (+) battery post (Fig. 3). Slide the rubber cover over the battery post. 13. Using the bolt and wing nut supplied with the battery, connect the negative (black) cable to the negative (–) battery post (Fig. 3). N ...

For your convenience, write the product model and serial numbers in the space below. Model No: Serial No. Read this manual carefully to learn how to operate and maintain your product correctly. Reading this manual will help you and others avoid personal injury and damage to the product. Although we design, produce and market safe, state-of-the-art products, you are responsible for using the product properly and safely. You are also responsible for training persons, who you allow to use the product, about s ...

severe hydraulic system damage may result. 5. Place a drain pan under the filter. 6. Remove the old filter and wipe the filter adapter, gasket surface clean. 7. Apply a thin coat hydraulic fluid to the rubber gasket on the replacement filter (Fig. 26). 8. Install the replacement hydraulic filter onto the filter adapter. Tighten it clockwise until the rubber gasket contacts the filter adapter, then tighten the filter an additional 1/2 turn (Fig. 26). 9. Clean up any spilled fluid. 10. Start the engine and let it run for about two minut ...

over the listed degree may cause the traction unit to become unstable. The data in the table assumes that the loader arms are fully lowered and that the factory installed tires are on the traction unit, inflated to the recommended pressure; raised arms and other tire types or pressure may affect the stability. Maximum Recommended Slope when Operating with: Configuration Front Uphill Rear Uphill Side Uphill Traction unit without attachment 10° 20° 18° T ...

• Check engine speed (1400 rpm idle and 3600 full throttle, ± 75) • Check spark plugs 400 hours • Change hydraulic filter1, 3, 5 • Inspect fuel lines for leaks Yearly/Storage • Change hydraulic oil1, 6 • Replace primary and secondary air filters1 • Replace the fuel filter1 • Touch up chipped paint 1More often in dusty, dirty conditions. 2Change oil after the first 50 operating hours. 3Change the hydraulic filter and torque the lug nuts after the first 8-10 ...

traction unit may become unstable which may result in loss of control. • Do not carry a load with the arms raised. Always carry loads close to the ground. Do not step off of the platform with the load raised. • Do not over-load the attachment and always keep the load level when raising the loader arms. Logs, boards, and other items could roll down the loader arms, injuring you. • Never jerk the control levers; use a steady motion. • Keep your hands, feet, hair, and loose clothing away from any moving parts. • Operate only in da ...