Sharp UX-108 Service Manual

IC2: VHiR96XFC3CID (96DFXL-CID) SWGAINI 0VD1 +5VD2 0VA NC NC RAMPIN 0VA 0VD2 D0 D1 D2 D3 D4 D5 D6 GP02 SWGAINO RCVO 0VD2 RLSDn RXD GP19 GP20 0VD2 GP21 EYEY 0VD2 DAOUT ADIN EYEX EYECLK NC NC NC DAIN ADOUT BYPASS RCVI TXLOSS3 TXLOSS2 TXLOSS1 NC NC 0VA TXOUT RXIN +5VA RS3 RS2 RS1 RS0 GP13 SEE NOTE 1 GP11 RTSn EN85n 0VD2 PORin XTLI XTLO XCLK YCLK +5VD1 24 100 99 98 97 96 95 94 93 92 91 90 89 88 87 86 85 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 D7 0VD2 ...

[7] Control PWB unit 162 VRS-TS2AD271J AA C Resistor(1/10W 270Ω ±5%) [R168] 163 VRS-TS2AD471J AA C Resistor(1/10W 470Ω ±5%) [R169] 164 VRS-TS2AD471J AA C Resistor(1/10W 470Ω ±5%) [R170] 165 RCILZ2139SCZZ AC C Coil(Z2139) [R171] 166 VRS-TS2AD471J AA C Resistor(1/10W 470Ω ±5%) [R172] 167 RCILZ2145XHZZ AF N C Coil(Z2145) [R174] 168 VRS-TS2AD000J AA C Resistor(1/10W 0Ω ±5%) [R175] 169 VRS-TS2AD302J AA C Resistor(1/10W 3.0KΩ ±5%) [R176] 170 VRS-TS2AD623J AA C Resistor(1/10W 62KΩ ±5%) [ ...

1) Documents smaller than B6 (128mm x 182mm). 2) Documents thinner than the thickness of 0.06mm. 3) Documents containing creases, folds, or curls, especially those whose surface is curled (maximum allowable curl is 5mm). 4) Documents containing tears. 5) Carbon-backed documents. (Insert a white sheet of paper between the carbon back and the document carrier to avoid transfer of carbon to the carrier.) 6) Documents containing an easily separable writing material (e.g., those written with a lead pencil). 7) Transparent do ...

[1] Adjustments General Since the following adjustments and settings are provided for this model, make adjustments and/or setup as necessary. 1. Adjustments Adjustments of output voltage (FACTORY ONLY) 1. Install the power supply unit in the machine. 2. Set the recording paper and document. 3. When the document is loaded, power is supplied to the output lines. Confirm that outputs are within the limits below. Output voltage settings (1)FU100 (ICP-S07) is installed in order to protect IC’s from an over- current generated in the motor drive circ ...

– 1 – 57 57 12 40 41 46 46 50 B6 B6 B4 B1 B7 B4 B4 B5 B4 B4 B4 B4 B1 B1 B4 B4 B4 B4 B4 48 42 37 33 28 34 31 32 30 38 35 39 29 29 22 24 55 36 25 23 54 21 10 17 13 20 19 43 18 8 56 45 51 52 53 47 44 44 49 9 6 10 2 58 2 7 11 14 1 5 4 3 3 26 27 B4 B4 15 DOCUMENT GUIDE UPPER (NON CUTTER MODEL) (CUTTER MODEL) DRIVE UNIT (CUTTER MODEL) (CUTTER MODEL) 59 60 ...

(1) TEL/LIU block operational description 1) Block diagram 2) Circuit description The TEL/LIU PWB is composed of the following 7 blocks. 1. Speech circuit section 2. Dial transmission section 3. Speaker amplifier section 4. Ringer circuit section 5. Externally connected TEL OFF HOOK detection circuit 6. CI detection circuit 7. Signal/DTMF transmission level & receiving level Fig. 5 3) Block description 1. Speech circuit section • The receiver volume is an electronic volume type, this model is switch in 3 steps. 2. Dial transmis ...