SpeakerCraft TIME One Owner's Manual

Serial hardware flow control (i.e., RTS/CTS and DTR/DSR) and software flow control (i.e., XON/XOFF) protocols are not used and will be ignored. Programming Commands All command packets shall be of the following format: * Notes: Each <…> represents a single ASCII character. represents a carriage return. The Controller will ACK each recognized command with an asterisk (*). The Controller will NACK eac ...

Command Equivalent Remote Button/Action Action *C00 Control Sets the Selected Speaker in Control Mode *C01 None Sets Speaker 1 in Control Mode *C02 None Sets Speaker 2 in Control Mode *C03 None Sets Speaker 3 in Control Mode *C04 None ...

TIME Controller front panel starts moving to its programmed default position. This occurs in a fixed amount of time and is not programmable. However, to avoid retracting the loudspeakers in soft pas- sages, especially in movies there is a programmable turnoff time. The installer can choose the amount of time they would like to have before the speakers turn off and retract into the ceiling. The first four positions of the dip switches on the rear panel of the TIME Controller program this delay Time. Table 1 shows the delay times that can be progra ...

TIME Controller front panel starts moving to its programmed default position. This occurs in a fixed amount of time and is not programmable. However, to avoid retracting the loudspeakers in soft pas- sages, especially in movies there is a programmable turnoff time. The installer can choose the amount of time they would like to have before the speakers turn off and retract into the ceiling. The first four positions of the dip switches on the rear panel of the TIME Controller program this delay Time. Table 1 shows the delay times that can be progra ...

? Note: Each <…> represents a single ASCII character. represents a carriage return. The Controller will respond to each recognized query by responding with the queried parameters and ending with a ‘?’. The Controller will NACK each unrecognized query with a period (.). RS-232 Connector Wiring Trigger Input Wiring IR RECEIVER WIRING (typical) TIME Series Controller Page 8 Query Controller Response ?D 00? (All switches Off) 01? (Swit ...

Serial hardware flow control (i.e., RTS/CTS and DTR/DSR) and software flow control (i.e., XON/XOFF) protocols are not used and will be ignored. Programming Commands All command packets shall be of the following format: * Notes: Each <…> represents a single ASCII character. represents a carriage return. The Controller will ACK each recognized command with an asterisk (*). The Controller will NACK eac ...

The wiring for the Cat 5 Cable is a straight thru connection. Typically the following convention is used: The important thing is that pin 1 of the Speaker Side connector and pin 1 of the Electronics side connector are connected. Same for Pin 2, Pin 3, etc. So that all 8 pins of the speaker side connector are connected to the corresponding pin on the electronics side connector. TIME Remote (for reference only) Page 5 TIME Series Controller RJ45 Pin# Wire Color (T568B) Wire Diagram (T568B) Signal 1 2 3 4 5 6 7 8 White Orange Orange White Green Blue Whit ...

Page 10 1. Pressing Zone 1-4 chooses the speakers in that zone and allows presets, on/off to work on those speakers 2. Pressing Speaker Selector + button sends control to the next speaker that can be controlled in that zone in a clock- wise order. Pressing Speaker Selector - button sends control to the next speaker that can be controlled in that zone in a counter clockwise order. The LED on the loudspeaker se- lected should light on the on the unit (the light on the remote is not synchronized to the speaker being selected it is only a visual indication that you have move ...