Wildix W24FXS Quick Installation Manual

1. Overview and LED indications 3 2. Connection to power supply 3 3. Connection to the network 3 3. Connection of analog phones 4 4. Configuration of the gateway 4 5. Reset of the gateway 4 Wildix W24FXS 2015 media gateway - Quick Installation Guide 2

Rear panel • ON/OFF Switch • Power supply jack AC 110V~240V, 50-60Hz • RJ21 Port for patch panel connection Front panel • 1 WAN port RJ45 10/100 base-T • 1 Console port RJ45 with RS232 standard to connect DB9 • 1 RST switch to perform the factory reset • 1 PWR LED: - solid green indicates that the gateway is powered on • 1 RUN LED: - turns solid green for a few seconds once the gateway is powered on; - fast blinking indicates that all ports are registered successfully - slow blinking indicates that ports failed to register - off (when connected to power) indicates that the gateway doesn’t boot up • 1-24 ports for connection of analog devices • 1-24 LEDs: - solid green indicates that the port is in use - off (when connected to power) indicates that the port is idle 2. Connection to power supply 1) Connect the gateway to the Power Supply using the cable provided 2) Turn the switch situated on the rear panel into “ON” position 3. Connection to the network 1) Connect the gateway’s WAN port to Wildix Switch using Ethernet cable 2) By default the gateway is set up with the static IP address, please follow this guide to change the mode to DHCP client. Notes • the gateway should be connected via Ethernet cable to the same network as the PBX or an external DHCP server (for instance its Router) • as soon as the DHCP server assigns an IP address to the gateway, you can pass to the next step of the gateway configuration • In case the PBX is used as a DHCP server, the gateway is detected on the network automatically • In case an external DHCP server is used, check the list of the active leases to detect the IP address assigned to the gateway Wildix W24FXS 2015 media gateway - Quick Installation Guide 3

• You can connect analog devices directly to ports marked 1-24 • Otherwise connect the patch panel to the RJ21 port situated on the rear panel using the connector provided. 4. Configuration of the gateway • Follow our online guide to provision the media gateway For remote/unreachable media gateways behind NAT/Firewall, follow our online guide to remote provisioning. • Follow our online guide to assign the ports of the media gateway 5. Reset of the gateway The switch marked as “RST” is situated on the front panel of the gateway. 1) use the paper clip or the object of the similar shape to press the button 2) hold the button pressed for more than 7 seconds to restore the gateway to the factory settings. 3) reboot the gateway for the changes to take the effect Note: keep the button pressed for just 3-5 seconds, to restore the default IP and user name / password (in this case all the other configurations are kept); it is necessary to reboot the Wildix W24FXS 2015 media gateway - Quick Installation Guide 4