American DJ FLASH 2C User Instructions

Model: Flash-2C™ SPECIFICATIONS: Power: 110V/60Hz Weight: 8 lbs. Size: 19” x 3.5” x 5” Fuse: 15A Thank you for purchasing this American DJ® product. For your convenience this products ready to be used, there is no assembly required. Please read the following instructions before installing or using your new unit. Operating Instructions: The American DJ® Flash-2C, flash tube controller is ideal for mobile DJ’s and club use. One Flash-2C will control 4 expandable lines of Flash Tubes. POWER- ON & OFF 1,2,3,4 - ON & OFF for individual lines. SYNC - All tube flash at the same time AUTO - Flashes line of tubes one by one SPEED knob - Controls speed of chase. RATE knob - Controls rate of pulse (ie. speed between triggering strobe) of the Flash Tubes. TRIGGER - starts a flash run when in manual mode MANUAL - allows you to TRIGGER flash manually. MODE SELECT - Choose 1 of 4 modes to chase in. 1. Rebound 2. Crossover 3. Reverse 4. Forward For service, contact your American DJ® dealer. American DJ® User Instructions Flash-2C™ POWER ZONE CONTROL PULSE CONTROL 1 2 3 4 SYNC AUTO MODE SELECT FLASH MANUAL SPEED RATE AUDIO TRIGGER SET UP: Link the Flash Tubes to the Flash-2C™by inserting tube connectors into controller sockets on the back of unit. The maximum length to first Flash Tube™is 10 ft, any more and you will have to use a Flash Buffer. If you connect more than 30 Flash Tubes in any single line use a Flash Buffer™to boost signal. At the end of each line connect a Flash-Term™. If you don’t use one the Flash Tubes will work but not properly. Plug Flash-2C™and any Flash Buffer™into power. Refer to Operating instructions for use. 4 CHANNEL FLASH TUBE CONTROLLER Caution! Always use appropriate cables and connectors. Remember to always replace with same fuses. Always keep controllers dry. Don’t exceed load and length limitations