American Time SiteSync IQ Installation And Operation Manual

SiteSync IQ Wireless Installation Manual Glossary Appendix Troubleshooting Clock Installation System Controller Installation Introduction Appendix A: Ethernet Timekeeping NIST Internet Time Servers Using the SiteSync IQ System Controller as a Time Server The SiteSync IQ System Controller with Ethernet option can be used as a time server supporting the SNTP and Daytime protocols and can be used to synchronize computers or other devices via the Ethernet. A typical configuration would be a SiteSync IQ System Controller with GPS and Ethernet options, where GPS is used as the ti ...

SiteSync IQ Wireless Installation Manual Glossary Appendix Troubleshooting Clock Installation System Controller Installation Introduction Clock Troubleshooting Wireless Analog Clock Troubleshooting Quiet Mode- With Quiet Mode enabled, clocks may not correct until the hours of 12AM-6AM. If clock corrections are needed during the day, Quiet Mode can be disabled by pressing 3-5-7 on the system controller (reference Appendix J in the SiteSync IQ Wireless Installation Manual). If ALL clocks are not synchronizing: 1. Review System Controller troubleshooting. (Reference “Trouble ...

SiteSync IQ Wireless Installation Manual Glossary Appendix Troubleshooting Clock Installation Introduction Introduction The American Time SiteSync IQ wireless clock series offers a selection of clocks to match a wide variety of application requirements. Plastic case, steel case, analog and digital styles will provide years of maintenance-free service. SiteSync IQ Wireless Analog Clock Features • Wireless time synchronization • Built-in ultra-sensitive UHF receiver for facility wide signal reception • Plug and play installation with no manual adjustments • Battery clo ...

38 Glossary Appendix Troubleshooting Clock Installation System Controller Installation Introduction SiteSync IQ Wireless Installation Manual Remote Connect Web Interface Glossary Appendix Troubleshooting Clock Installation System Controller Installation Introduction Impulse – If the system is to operate with impulse clocks and a impulse clock code is selected the Manually Adjust Impulse Clocks box will appear. For example, setting the Clock Code selector to 2 will enable impulse clock operation. Figure 6 • The Calculated Adjustment will automatically adjust the impulse clo ...

64 SiteSync IQ Wireless Installation Manual Glossary Appendix Troubleshooting Clock Installation System Controller Installation Introduction Clock Troubleshooting Wireless Digital Clock Troubleshooting 1. If all clocks are not synchronizing: a. Review System Controller troubleshooting. b. Contact American Time Technical Support at 800-328-8996. 2. If only some clocks are not synchronizing, continue with the troubleshooting steps. 3. Confirm signal – Reference pictures below. a. Wait until the top of the minute and verify time synchronizes to the System Controller. nNote: Aft ...

56 SiteSync IQ Wireless Installation Manual Glossary Appendix Troubleshooting Clock Installation System Controller Installation Introduction Troubleshooting GPS If you have trouble synchronizing to GPS, follow these troubleshooting steps: 1. If GPS receiving antenna has been connected to the SiteSync IQ System Controller for less than 25 minutes, the GPS time signal may be inaccurate. Allow more time. If still not synchronizing follow these steps: Press: P5, to check the GPS signal status. Press: 1, to check signal status. If no signal was received, continue to Step 2. If sign ...

SiteSync IQ Wireless Installation Manual Glossary Appendix Troubleshooting Clock Installation System Controller Installation Introduction User Notes ...

62 SiteSync IQ Wireless Installation Manual Glossary Appendix Troubleshooting Clock Installation System Controller Installation Introduction Troubleshooting Wired Signal Circuit If you have trouble operating wired signal circuits, follow these troubleshooting steps: 1. Signal circuits not responding to programmed events: a. Make certain that the system controller status is set to AUTO: Press 8, enter User Lock, if applicable, and press O. b. Confirm that signal circuits are enabled. From the View Circuits screen: Press 3 to enter the Enable Circuits screen to view or change th ...