Avaya P333R Operation & User’s Manual

Avaya P333R User’s Guide 223 Privileged Mode rmon2 host Command Use the rmon2 host command to enable the RMON2 host application. Use the no version of this command to disable the application. The syntax for this command is: [no] rmon2 host rmon2 matrix Command Use the rmon2 matrix to enable the RMON2 Matrix application. Use the no version of this command to disable the application. The syntax for this command is: [no] rmon2 matrix Example: Router-N(configure)# rmon2 matrix rmon2 protocol-dist Command Use the rmon2 protocol-dist to enable the RMON2 Protoco ...

72 Avaya P333T-PWR User’s Guide show web aux-files-url Use the show web aux-files-url command to display the URL/Directory from where the P330 can access the Device Management auxiliary files (for example help files). The syntax for this command is: show web aux-files-url show intelligent-multicast Use the show intelligent-multicast command to display the intelligent multicast configuration. The syntax for this command is: show intelligent-multicast Output Example: P330-N> show intelligent-multicast Intelligent-multicast configuration: ------------------------------ ...

180 Avaya P333R User’s Guide RIP Commands Configure Mode router rip Command Use the router rip command to configure the Routing Information Protocol (RIP). The no form of this command disables RIP. The default state is disabled. The syntax for this command is: [no] router rip Example: To enable the RIP protocol: Router-N(configure)# router rip Table 7.3 RIP Commands Command Page router rip 180 network 181 redistribute 181 ip rip rip-version 182 default-metric 182 ip rip send-receive-mode 183 ip rip default-route-mode 183 ip rip poison-reverse 184 ip rip s ...

Avaya P333T-PWR User’s Guide 79 no rmon event Use the no rmon event command to delete an existing RMON event entry. The syntax for this command is: no rmon event hostname Use the hostname command to change the Command Line Interface (CLI) prompt of a module. The current switch number always appears at the end of the prompt. The syntax for this command is: hostname [] Note: If this command is to be implemented on a switch other than the stack master, a session should be opened to the relevant switch. hostname_string none – displays c ...

Redundancy Routing protocols naturally provide some level of redundancy. However, IP stations that are manually configured with a single ‘default gateway’ IP address do not naturally recover when their default gateway fails. These stations do not automatically try to use other routers or Layer-3-switches connected to the same subnet. The P333R supports two router redundancy protocols, VRRP and SRRP, to solve this problem. Virtual Router Redundancy Protocol (VRRP) VRRP is an IETF protocol designed to support redundancy of routers on the LAN, a ...

168 Avaya P333R User’s Guide show ip unicast cache networks detailed Command Use the show unicast cache networks detailed command to list the networks and hosts that are handled by the hardware unicast cache database. The syntax for this command is: show ip unicast cache networks detailed Output Example: Router-N> show ip unicast cache networks detailed 192.168.6.0 24 Showing 3 rows show ip unicast cache host Command Use the show ip unicast cache host command to list hosts that are used as the destination devices. The syntax for this command is: show ip u ...