American Dynamics VM2000 Installation Instructions
Text of the manual
Remove the appropriate video output board by
loosening the lower mounting screw and gently lifting
up on the BNC bracket (c) until the board disengages
from the motherboard connector (d) . Move the
board slightly toward the rear of the unit until it
disengages from the backplane connector(e). Lift
the board from the unit. Refer to diagram 2.
VM2000 Text Over
VM2000 Text Overlay Board
1-2
Sensormatic
SENSORVISION SYSTEMS
Installation Instructions, continued
V8000-0750-01 Rev A
®
Press down on the BNC bracket of the board until
the board is seated in the motherboard connectors
as shown by diagram 4 .
a. top edge connector
b. bottom edge connector
7.
Replace the right top cover plate and tighten the
fastening scre
