Compass Navibe GB621 Quick Installation Manual

Quick Installation Guide Bluetooth GPS Receiver Model: GB621 GB621 Quick Installation Guide v.1.0 Quick Installation Guide Bluetooth GPS Receiver Model: GB621 Before You Start Your new COMPASS Bluetooth GPS allows you to turn any Bluetooth™ enabled PDAs (Pocket PC) or PCs into a GPS Navigation System using Bluetooth Technology. 1. Hardware Description………………………………………2 2. State Table of LED……………………………………...….4 3. Pocket PC Setup ……………………………………………6

Hardware Description The Bluetooth GPS has three LED indicators. The first is low power LED indicator that is named LED1. The second is GPS & Charge status LED that is named LED 2. The third is Bluetooth status LED that is named LED 3. The status table of LED shows as follows: External Antenna Connector (MMCX type) Power Switch DC Charging Jack Low Power LED (red color) (LED1) GPS (green color) & Charge (red color) LED (LED2) Bluetooth LED (blue color) (LED3) Power Switch GB621 Quick Installation Guide v.1.0 PLEASE CHARGE BATTERY FULLY BEFORE INITIAL USE. (When fully charged, red color-LED2 will automatically switch off.)

State Table of LED LED1 Low Power LED Description LED1 Color and Action Low Power Red off No Red on Yes LED2 GPS & Charge LED Description LED2 Color and Action Battery Charged Position Fixed Green on N/A No Green Flash N/A Yes Red Flash Charging N/A Red off OK N/A LED3 Bluetooth LED Description LED3 Color and Action Bluetooth Pairing Blue Flash No Blue on Yes Turn on To turn on the receiver, push the power switch to “I” position. The green LED (LED 2) indicator will steady on for searching GPS satellites. The left blue LED (LED 3) indicator will start flashing for searching Bluetooth device. Power Switch GB621 Quick Installation Guide v.1.0 Turn off To turn off the receiver, push the power switch to “O” position. All of the LED indicators will turn off. Low Power The right LED (LED 1) indicator will turn RED when battery power becomes low. Connect the receiver to a powers source to continue to recharge the battery. Charging The second LED (LED 2) red indicator will flash when the battery is being charged. When fully charged, the RED indicator will switch off. Search for Bluetooth Device The left LED (LED 3) blue indicator will flash for pairing Bluetooth signals. When connected, the left LED (LED3) blue indicator will become to steady on. Position Fixed for GPS The second LED (LED 2) green indicator will steady on for searching satellites. When fixed, the second LED (LED2) green indicator will become to flash.

Pocket PC Setup Tap “Bluetooth Manager” from Start Menu Note: In “Bluetooth: Device Pairing” window you will required to enter the Passkey number 0000 when opening the port in your GPS program. GB621 Quick Installation Guide v.1.0 Tap New > Connect Tap Explore a Bluetooth device, then tap Next Tap where indicated to choose a device. And select the picture marked “BT GPS” to continue

The PDA will begin retrieving services as shown above Select “GPS OUTPUT” and tap Next GB621 Quick Installation Guide v.1.0 Tap Finish to establish the BT GPS Bluetooth GPS connection In the future, you may establish the connection from the shortcut, “BT GPS: GPS OUTPUT”

FCC Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Notice: Any changes or modification not expressly approved by the party responsible could void the user's authority to operate the device. Technical Support If you have any questions or problems installing the Bluetooth GPS, please contact Technical Support. Hours: Weekdays 9 a.m. ~ 6 p.m. Taiwan http://www.navibe.com E-mail: [email protected]