Custom Audio Electronics MT558 Operation & User’s Manual

tronic means, is forbidden. While guaranteeing that the information contained in it has been carefully checked, CUSTOM ENGINEERING SPA and other entities utilized in the realization of this manual bear no responsibility for how the manual is used. ...

1 INTRODUCTION ...................................................................................................................................................... 5 1.1 General safety information ............................................................................................................................... 5 1.2 General f ...

• Read and keep the instructions which follow. • Follow all warnings and instructions indicated. • Before cleaning the mechanism, disconnect the power supply. • Clean the mechanism with a damp cloth. Do not use liquid or spray products. • Do not operate the mechanism near water. • Do not use the mecha ...

6 HEATER ENERGY 5°C 0,27 mJ/dot (1,8 ms) 25°C 0,21 mJ/dot (1,4 ms) 45°C 0,18 mJ/dot (1,2 ms) DRIVER SATURATED RESISTANCE (RIC) 13 Ω EXTERNAL DIMENSIONS (W x D x H) 84,55 x 44,25 x 20 WEIGHT 72 gr OPERATION VOLTAGE RANGE LOGIC 7 V OPERATION VOLTAGE DOTLINE HEAD 5 V CURRENT CONSUMPTION Printing at 5Vcc : 1,9 A (Head with 64 dots ...

2.1 Front exterior view of MT558 1. Motor 2. Print Head 3. Head up lever 4. Sensor Head up detection 5. Print Head cable 6. Knob paper feed A- Paper outfeed B- Paper input C- Paper end sensor 1 2 5 4 3 6 B C A 2. INSTALLATION AND USE User Manual MT558 7 ...

1. Motor 2. Print Head 3. Head up lever 4. Sensor Head up detection 5. Print Head cable 6. Knob paper feed A- Paper outfeed B- Paper input C- Paper end sensor B C A 1 2 5 4 3 6 2. INSTALLATION AND USE 8 MT558 User Manual ...

The mechanism has two interface connectors (see following fi gure), that includes the thermal head connector and motor-paper control connector. Thermal head connector 1 28 Motor-paper control connector 1 10 In the table below are described the connector specifi cations and functions: No. Connector Pin No. TYPE 1 Ther ...

The connector’s pin assignments is as follows: No. SIGNAL FUNCTION No. SIGNAL FUNCTION 1 NC Not connected 15 STB2 Strobe2 signal (Active low) 2 NC Not connected 16 STB3 Strobe3 signal (Active low) 3 GND Ground 17 STB4 Strobe4 signal (Active low) 4 GND Ground 18 STB5 Strobe5 signal (Active low) 5 GND Ground 19 STB ...