Daikin DCM601A51 Installation Manual

DCM601A51 intelligent Touch Manager 25 English 3 Installation The intelligent Touch Manager can be installed in the following three ways: • Wall mounting: The intelligent Touch Manager is hooked onto the wall mounting metal plate secured to the wall. • Flush wall mounting: The rear portion of the intelligent Touch Manager is embedded in the wall. • Direct mounting to control enclosure: The intelligent Touch Manager is directly installed to the control enclosure using fixing screws. Wall mounting Flush wall mounting Direct moun ...

DCM601A51 intelligent Touch Manager English 1.3.3 Side face On the left side face of the intelligent Touch Manager, a USB port cover is provided. You use this cover during setup after installation or during maintenance. You also see an attached label, bearing the model, weight, power ratings and the serial number of the intelligent Touch Manager. [ ] Pulling up the rubber cover reveals a USB socket. This socket can be raised 90 degrees, so you can plug in a USB device to it from the front direction when there is n ...

DCM601A51 intelligent Touch Manager 37 English NOTE The parameter number cannot be changed to “00” when the intelligent Touch Manager is not powered on. Power on the intelligent Touch Manager and wait for a while before trying to operate the remote controller. You cannot change the parameter number to “00” also when the intel- ligent Touch Manager is not communicating with the indoor units normally. Make sure that the cables are connected correctly. 3. Press the Timer ON/OFF button to make the “GROUP” indicator blink. You are now ready to change ...

DCM601A51 intelligent Touch Manager 25 English 3 Installation The intelligent Touch Manager can be installed in the following three ways: • Wall mounting: The intelligent Touch Manager is hooked onto the wall mounting metal plate secured to the wall. • Flush wall mounting: The rear portion of the intelligent Touch Manager is embedded in the wall. • Direct mounting to control enclosure: The intelligent Touch Manager is directly installed to the control enclosure using fixing screws. Wall mounting Flush wall mounting Direct moun ...

DCM601A51 intelligent Touch Manager English 1.3 Understanding where terminals and switches are located Understand the arrangement of terminals and the location of openings on the unit and plan how to route the cable and in which order to connect its wires to facilitate the instal- lation procedure. For connection details including the cable type and terminal size, refer to “2. Connection”. 1.3.1 Rear face Most terminals are located on the rear face of the intelligent Touch Manager. However, they are covered with a terminal cover for safety reasons. Re ...

DCM601A51 intelligent Touch Manager English 6. Press the Inspection/Test Operation button. You are now brought back to the screen shown in Step 6-2. SETTING GROUP HH 4.8.3 Procedure for a navigation remote controller The following describes how to assign a DIII-NET address when a navigation remote controller is installed. NOTE You cannot perform the following procedure when the display backlight is off. In this case, press any key to turn on the backlight before starting the procedure. 1. Press and hold the Cancel button for 4 second ...

DCM601A51 intelligent Touch Manager 25 English 3 Installation The intelligent Touch Manager can be installed in the following three ways: • Wall mounting: The intelligent Touch Manager is hooked onto the wall mounting metal plate secured to the wall. • Flush wall mounting: The rear portion of the intelligent Touch Manager is embedded in the wall. • Direct mounting to control enclosure: The intelligent Touch Manager is directly installed to the control enclosure using fixing screws. Wall mounting Flush wall mounting Direct moun ...

DCM601A51 intelligent Touch Manager 17 English To set the intelligent Touch Manager to SLAVE, use the DIII MASTER switch located under the front slide cover. Placing the DIII MASTER switch in the upper position (labeled as “SLAVE”) changes it to a SLAVE. To install multiple centralized controllers, set only the highest priority controller to MAS- TER and all other controllers to SLAVE according to the following order of priority: High (1) Interface for use in BACnet (2) Interface for use in LONWORKS (3) intelligent Touch Manager (MASTER), i ...