DCS RF151 Installation Instructions & User Manual

●● Avoid leaning on the cabinet door. You may bend the door hinge or tip the ice maker. ●● Exercise caution when sweeping, vacuuming or mopping near the front of the ice maker. Damage to the grille and/or switch can occur. ●● Periodically clean the inside of the ice maker components and inside of the ice maker. ●● Clean the exterior of the ice maker regularly. See ‘Cleaning the ice maker’ for further instructions. Cleaning the ice maker Over time, mineral build up may be seen in the ice maker. This build up will need to be removed to ensure proper i ...

! WARNING! Electric Shock Hazard Read and follow the safety and warnings outlined in this user guide before operating this appliance. Failure to do so can result in death, electric shock, fire or injury to persons. Use this appliance only for the intended purpose as described in the user guide. IMPORTANT SAFETY INSTRUCTIONS WARNING! When using this appliance always exercise basic safety precautions including the following: ●● This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of expe ...

4 Remove the drain plug at the bottom of the reservoir to drain any remaining water and then reinstall. Drain plug in bottom of reservoir 5 Allow the ice to fall from the evaporator, remove and discard slab of ice. 6 When cleaning the interior of this product use a nickel free cleaner and follow the manufacturer’s instructions for use. Add the recommended amount of concentrated cleaning solution to the reservoir of the ice maker by pouring the solution on the evaporator. This will then flow down into the reservoir. Ice slab Remove ice slab and discard Gri ...

If you require a drain pump for your ice maker this can be purchased separately online at www.dcsappliances.com or by contacting the Customer Care Center. Your drain pump will need to be installed by a DCS by Fisher & Paykel trained and supported service technician. After installation, ensure the 3/8” I.D. (discharge tubing) which is coiled up and attached to the back of the ice maker is plumbed in and connected to a sanitary sewer. The maximum lift of the drain pump is 8ft (2.44m) through the 3/8” I.D. tubing. IMPORTANT! ●● This drain pum ...

Datum: front of chassis Datum: bottom of chassis ...

1 Unplug ice maker from the electrical supply and remove the rear access cover from the ice maker. 2 Unscrew the leveling leg in the back corner until the end of the threaded portion is flush with the threaded nut insert in the base (A). 3 Unscrew the 4 hose clamps and remove the 3 hoses from the front of the drain pump (B). 4 Rotate the drain pump and remove from the ice maker (C). It may be necessary to disconnect the ground wire connection in the back flange of the cabinet (D). 5 Disconnect the ice maker power cord from the drain pump (E). 6 To drain water from ...

use you automatically receive a two year limited warranty covering parts and labor for servicing within the 48 mainland United States, Hawaii, Washington DC and Canada. In Alaska the limited warranty is the same except that you must pay to ship the product to the service shop or the service technician’s travel to your home. Products for use in Canada must be purchased through the authorized Canadian distribution channel to ensure regulatory compliance. If the product is installed in a motor ...