Extron electronics SM 26 Operation & User’s Manual

3 Installation NOTE: Unless otherwise stated, mounting hardware is not included. This section describes the installation and setup of the SM 26 surface mount speaker. Topics include: •� Installating the Speaker Mounting Plate •� Mounting to a Wall Stud •� Yoke Mounting the SM 26 •� Attaching a Secondary Support Cable •� Attaching the Speaker to the Mounting Plate •� Setting the Tap Selector Switch (SM 26T Model Only) •� Using the Security Key to Lock and Unlock the Speaker •� Removing the Speaker from the Mounting Pla ...

7 Routing the wires with the 10° mounting adapter Route the speaker cable through the 10° mounting adapter and the 0° mounting plate, and attach the adapter to the 0° mounting plate using the four included screws and washers, as shown below. Then attach the wire ends to the quick connect contacts using a small screwdriver, as shown below. Figure 8. Routing Wires Through the Adapter and Plate NOTE: If surface mounting, route wires through alternate access points. 0° Mounting Plate Alternate Access Point Alternate Access Points 10° Mounting Adap ...

10 Attaching the Speaker to the Mounting Plate ATTENTION: By default, the SM 26 speaker is shipped unlocked. When mounting the speaker to the mounting plate, be sure that the speaker is unlocked. Failure to place the speaker in the unlocked position will result in damage to the speaker lock mechanism should an attempt be made to mount a locked speaker (see “Using the Security Key to Lock and Unlock the Speaker” on page 12). NOTE: If the secondary attachment point is being used, see the “Attaching a Secondary Support Cable” on page 9 for inst ...

4 The mounting plate can be installed vertically or horizontally, as shown below. Catch Tab Vertical Mounting Figure 3. Positioning the Mounting Plate NOTE: Observe all applicable building codes and local ordinances when installing the speaker. Horizontal Mounting ...

7 Routing the wires with the 10° mounting adapter Route the speaker cable through the 10° mounting adapter and the 0° mounting plate, and attach the adapter to the 0° mounting plate using the four included screws and washers, as shown below. Then attach the wire ends to the quick connect contacts using a small screwdriver, as shown below. Figure 8. Routing Wires Through the Adapter and Plate NOTE: If surface mounting, route wires through alternate access points. 0° Mounting Plate Alternate Access Point Alternate Access Points 10° Mounting Adap ...

iv Contents Introduction ................................................... 1 About this Guide ................................................. 1 About the SM 26 Surface Mount Speaker .......... 1 Features ............................................................. 1 Application Diagram ........................................... 2 Installation ..................................................... 3 Installing the Speaker Mounting Plate ................. 3 Mounting to a Wall Stud ..................................... 5 Yoke Mounting the SM 26 ...... ...