Apple Mac Pro Access Panel Replacement Instructions Manual
Read Online
Read the Apple Mac Pro Access Panel Replacement Instructions Manual online using the built-in PDF viewer.
Text of the manual
Mac Pro
073-1060 Rev. A
Optical Drive
Replacement Instructions
Follow the instructions in this document carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Note: The Mac Pro computer can accommodate two optical drives in the optical drive bay. If the
computer has only one optical drive, it is installed in the top position.
Tools Required
The only tool required for this procedure is a Phillips #1 screwdriver.
Opening the Computer
Shut down the computer.
Warning: Always shut down the computer before opening it to avoid damaging its
internal components or the components you are installing. Do not open the computer
or attempt to install items inside it while it is on.
Wait 5 to 10 minutes to allow the computer’s internal components to cool.
Warning: After you shut down the system, the internal components can be very hot. You
must let the computer cool down before continuing.
Unplug all external cables from the computer except the power cord.
Touch the metal PCI access covers on the back of the computer to discharge any static
electricity from your body.
Important: Always discharge static before you touch any parts or install any
components inside the computer. To avoid generating static electricity, do not walk
around the room until you have finished working and closed the computer.
1.
2.
3.
4.
Mac Pro Optical Drive 2
Unplug the power cord.
Hold the side access panel and lift the latch on the back of the computer.
Warning: The edges of the access panel and the enclosure can be sharp. Be very careful
when handling them.
Remove the access panel and place it on a flat surface covered by a soft, clean cloth.
5.
6.
7.
Mac Pro Optical Drive 3
Removing the Installed Optical Drive
Carefully lay the computer on its side so that the open side faces up.
Important: Make sure the latch on the back panel is in the up position. When the latch is
down, the optical drives and carrier are locked in place and you will not be able to remove
them.
Locate the optical drive.
Pull the optical drive carrier part way out of the computer.
1.
2.
3.
Mac Pro Optical Drive 4
Disconnect the power and ribbon cables from the optical drive(s) and remove the carrier.
Remove the four mounting screws and remove the optical drive from the carrier.
4.
5.
Mac Pro Optical Drive 5
Installing the Replacement Optical Drive
Important: Use the original Apple cables that came with the computer when you install or
replace the optical drives.
Use the four screws from the original drive to mount the replacement drive in the carrier.
Note: If you are adding a second drive to the carrier, use the four screws stored on the back
of the drive carrier to secure the drive to the carrier.
1.
Mac Pro Optical Drive 6
Attach the power and ribbon cables to the back of the drive(s).
Important: Attach the connector on the end of the optical drive ribbon cable and the
connector in the middle of the optical drive power cable to the top drive. If there is a second
drive in the carrier, attach the remaining optical drive ribbon and power connectors to the
bottom drive.
Slide the optical drive carrier over the guides and into place in the optical drive bay.
Closing the Computer
Replace the access panel.
Note: Make sure the latch is in the up position before replacing the access panel. If the latch
is down, the access panel will not seat correctly in the enclosure.
Push the latch down to close and secure the access panel.
Warning: Never turn on the computer unless all of its internal and external parts are
in place and it is closed. Operating the computer when it is open or missing parts can
damage it or cause injury.
2.
3.
1.
2.
Mac Pro Optical Drive 7
Apple Computer, Inc.
© 2006 Apple Computer, Inc. All rights reserved.
Under the copyright laws, this document may not be copied, in whole or in part, without the
written consent of Apple.
Every effort has been made to ensure that the information in this document is accurate. Apple is
not responsible for printing or clerical errors.
Apple
1 Infinite Loop
Cupertino, CA 95014-2084
USA
+ 1 408 996 1010
http://www.apple.com
Apple, the Apple logo, Mac, Macintosh, and Mac Pro are trademarks of Apple Computer, Inc.,
registered in the U.S. and other countries.