ICS 613GC Operator's Manual

TITLE 613GC OPERATOR’S MANUAL 7 TECHNICAL SPECIFICATIONS Engine Type 2-stroke Single Cylinder Air Cooled Displacement 4.9 cu-in (80cc) Horsepower 5.7 HP (4.2 kw) @ 9,000 RPM Torque 37.2 in-lbs (4.2 Nm) Engine Speed 11,500 +/- 500 rpm 2,800-3,200 rpm idle Diamond Chain Speed In cut = 4,000 sfm No load = 5,300 sfm Weight 21 lbs (9.5 kg) with guide bar and diamond chain Cut Depth Up to 12 inches (30.5cm) 10 inches square (25.4cm) Dimensions 18 inches (46cm) length 11.5 inches (29cm ...

TITLE 613GC OPERATOR’S MANUAL 17 MAINTENANCE AIR FILTER IMPORTANT STARTER HOUSING ASSEMBLY It is common for concrete slurry to get inside the starter housing assembly during cutting. This can cause the starter pawls to stick and not engage when the rope is pulled. IMPORTANT • After each usage, thoroughly flush the starter housing assembly with water. (Figure 3) • Lubricate the starter pawls by spraying light weight oil into the starter housing through the vents. (Figure 3) � ...

TITLE 613GC OPERATOR’S MANUAL 16 MAINTENANCE Follow these simple maintenance guidelines and the 613GC Cut-Off Saw will keep running at its very best. AFTER EACH USE 1. Rinse the saw, guide bar and diamond chain with water. 2. Follow instructions on the Daily Maintenance Label, located on the air filter cover. 3. Inspect and tighten all fasteners as necessary. 4. Inspect drive sprocket for tooth wear and replace if tooth tips are pointed. 5. Inspect the starter cord. Replace i ...

TITLE 613GC OPERATOR’S MANUAL 13 OPERATION PRE-CUT CHECKLIST • Proper Diamond Chain Installation: The bumper should lead the segment into the cut. • Proper Diamond Chain Tension: The diamond chain should be tight but easily pulled around the guide bar by hand. • Ensure all safety devices are properly mounted and functional and that all controls are in proper working order. • Be sure there are no obstructions (plumbing, electrical conduit, air ducts) and no unnecessary peo ...